Filter
Top Products
15
LUBRICATION
1. The auger gear box is lubricated with grease at the
factory and is neither externally servicable, nor
requires checking. If disassembled for any reason,
lubricate with 2.5 ounces (by weight) of Alvania
grease, part number 737-0168A. Before
reassembling, remove old sealant and apply
Loctite Ultra Grey (759-3746) sealant or
equivalent.
2. The sprocket box assembly is also neither
externally servicable, nor requires checking. If
disassembled for any reason, lubricate with 5.0
ounces (by weight) of Benalene grease, part
number 737-0300A. Before reassembling, remove
old sealant and apply Loctite Ultra Grey (759-
3746) sealant or equivalent.
3. Apply penetrating oil to the cables of the chute tilt
handle assembly at least once a season.
4. Apply a good grade of spray lubricant to the univer-
sal joint of the chute crank, and to the pivot of the
chute tilt handle at least once a season.
5. Lubricate the chute crank spiral gear with a multi-
purpose automotive grease once a year.
6. Lubricate the telescoping square spindle of the
drive shaft (rear half) using 251H EP grease or an
equivalent No. 2 multi-purpose lithium grease
once a year.
7. Lubricate the bearings at each end of the auger
shaft with oil or spray lubricant at least once a sea-
son.
8. Although not required, it is advisable to remove the
auger shear bolts at least once a season and
spray penetrating oil, or similar lubricant, between
the auger tubes and auger shaft.
OFF-SEASON STORAGE
At the end of the snow season the following steps are
recommended:
1. Remove the snow thrower assembly from the trac-
tor.
2. Wash off any salt deposits which may have dried
on the snow thrower housing. Paint, or cover with
a light coat of oil, any exposed metal surfaces.
3. Lubricate bearings and pivot points with a good
grade of spray lubricant.
4. Store the snow thrower in a dry place.