Filter
Top Products
3
ASSEMBLY INSTRUCTIONS
Water Supply
(Cold Water Only)
• Water hose must be at least 3/4 inch
in diameter.
• Flow rate of water supply must not fall
below 2.5 GPM (gallons per minute).
• Flow rate can be determined by
running the water for one minute into
an empty 5-gallon container.
IMPORTANT PRECAUTIONS
– continued
• The water supply temperature must
not exceed 104°F/40°C.
• Never use the pressure washer to draw
in water contaminated with solvents, e.g.
paint thinners, gasoline, oil, etc.
• Always prevent debris from being drawn
into the unit by using a clean water
source.
Step 1 Attach one adapter bracket
to pressure washer by aligning holes on
adapter bracket with posts on the pressure
washer as shown. Tighten the two screws.
Step 2 Place detergent reservoir between
adapter brackets as shown. Attach second
adapter bracket.
OPERATING INSTRUCTIONS
4
Step 1 Connect the high pressure hose to
the unit’s high pressure outlet.
Step 2 Insert the spray wand of
your choice into the wand extension.
Press in against the spring tension and
twist into the locked position.
Step 3 Connect garden hose
to unit’s water inlet.
Step 4 Connect garden hose
to the cold water source and turn
water on completely.
Step 5 Plug the power cord into the power
outlet. Trigger the gun to eliminate trapped air,
wait for a steady flow of water to emerge from
the spray nozzle.
Step 6 Turn on the pressure
washer (I).
The motor starts only if
the trigger of the gun is pulled
and shuts off when the trigger is
released.
Step 4 Slide the spray wand extension
into the gun. Turn the wand collar onto the gun
threads until tight.
Step 3 Attach handle onto top of
adapter brackets. Press down to lock.
Tighten with screws as shown.
Note: Hose/cord caddy and trigger
gun holder must be on opposite sides.