Filter
Top Products
22
The drive pedal is properly adjusted when the hole
found in the double idler bracket has approximately
1-3/8" of travel with ten pounds of pressure applied
to the drive pedal. See Figure 19.
Figure 19
Adjust the drive pedal after replacing the drive belts
on your tractor, if necessary, as follows:
• Locate the speed control assembly on the
underside of the steering support bracket. See
Figure 20.
Figure 20
• Remove both hairpin clips from the pin which
is fastened to the speed control assembly (be
careful not to lose the small flat washers found
on the pin). See Figure 20.
• Remove the drive pedal return spring.
• Using two 9/16" wrenches, remove the pin
from the speed control assembly. See Figure
20.
Thread the idler adjustment rod inward or outward to
lengthen or shorten the travel of the double idler
bracket until proper adjustment is achieved.
• Reassemble by following the above steps in
reverse order.
BATTERY
The battery is sealed and is maintenance-free. Acid
levels cannot be checked.
• Always keep the battery cables and terminals
clean and free of corrosive build-up.
• After cleaning the battery and terminals, apply
a light coat of petroleum jelly or grease to the
terminals and over the positive terminal boot.
• Always keep the boot positioned over the
positive terminal to prevent shorting.
IMPORTANT: If removing the battery for any
reason, disconnect the NEGATIVE (Black) wire from
it’s terminal first, followed by the POSITIVE (Red)
wire. When re-installing the battery, always connect
the POSITIVE (Red) wire its terminal first, followed
by the NEGATIVE (Black) wire. Be certain that the
wires are connected to the correct terminals.
reversing them could change the polarity and cause
damage to your engine’s alternating system.
Charging
If the unit has not been put into use for an extended
period of time, charge the battery with a 12-volt
automotive-type charger at six amps for a minimum
of one hour (or until fully charged).
WARNING: Batteries give off an
explosive gas during and for some time
after charging. Charge battery in a well
ventilated area and do not allow a spark or
an open flame near the battery.
FUSE
A fuse is installed in your tractor’s wiring harness to
protect the tractor’s electrical system from damage
caused by excessive amperage. Always use the
same capacity fuse for replacement. If the electrical
system does not function, or your tractor’s engine
will not crank, first check to be certain that the fuse
has not blown.
It can be found under the hood mounted behind the
top of dash panel on the support bar. Pull the fuse
from its holder and compare it with Figure 21 to
determine if it is good or bad.
Figure 21
Front of Tractor
NOTE: View shown from above tractor.
Double Idler
Bracket
Idler
Adj. Rod
Hole
Speed Control
Assembly
Hairpin
Clips
Idler
Adj. Rod
Pin
Drive Pedal
Return Spring
Place Wrenches Here
Neutral
Return
Bracket
GOOD
BAD