Filter
Top Products
OPERATION
USING THE CLEAN=OUT TOOL (See Fig. 15)
In certain snow conditions, the discharge chute may be-
come clogged with ice and snow. Use the clean-out tool
to dislodge this blockage.
When cleaning, repairing, or inspecting, make
certain all controls are disengaged and the au=
get/impeller and all moving parts have stopped.
Disconnect the spark plug wire and keep the
wire away from the spark plug to prevent ac=
cidental starting.
Slower speeds are for heavier snow and faster speeds
are for light snow and transporting the snow thrower. It
isrecommended that you use a slower speed until you
are familiar with the operation of the snow thrower.
NOTE: When both traction drive and auger control levers
are engaged, the traction drive control lever will lock the
auger control lever inthe engaged position. This will allow
you to release your right hand from the handle and adjust
the discharge chute direction without interruptingthe snow
throwing process.
• Release the auger control lever and shut offthe engine.
• Remove the clean-out tool from it'smounting clip. Grasp
the tool firmly by the handle and push and twist the tool
into the discharge chute to dislodge the blockage.
After the packed snow has been dislodged, return the clean-
out tool to it's mounting clip by pushing it intothe clip.
• Make sure the discharge chute ispointed inasafe direc-
tion (no vehicles, buildings, people, orother objects are
inthe direction of discharge) before restarting the engine.
• Restart the engine, then squeeze the auger control
lever to the handle to clear snow from the auger hous-
ing and the discharge chute.
DISCHARGE CHUTE /[_
TOOL
FIG. 15
TO MOVE FORWARD AND BACKWARD (See Fig. 16)
SELF-PROPELLING, forward and reverse movement of
the snow thrower, iscontrolled by the traction drive control
lever located on the left side handle.
• Squeeze traction drive control lever to handle to engage
the drive system.
• Release traction drive control lever to stop the forward
or reverse movement of the snow thrower.
SPEED and DIRECTION are controlled by the drive speed
control lever.
Press downward on the speed control lever and move
lever to desired position BEFORE engaging the trac-
tion drive control lever. Be sure lever springs back and
locks into desired position.
TRACTION DRIVE
LEVER
DRaVE SPEED
CONTROLLEVER
FIG. 16
POWER STEERING OPERATION (See Fig. 17)
Steering triggers are used to assist in steering your
snow thrower. The triggers are located on the underside
of each handle. When a trigger issqueezed, itdisen-
gages the drive wheel on that side of snow thrower and
allows itto turn in that direction.
• To turn left - squeeze left side trigger.
• To turn right - squeeze right side trigger.
LH TURN RH TURN
TRIGGER TRIGGER
FIG. 17
CAUTION: Do not move speed control lever
when traction drive control lever is engaged.
Damage to the snow thrower can result.
12