Filter
Top Products
OPERATI
DISCHARGE DEFLECTOR
GASOLINE AUGER DRIVE CHUTE REMOTE
FILLER CAP CONTROL SPEED CONTROL CONTROL
ELECTRIC LEVER CONTROL LEVER LEVER
MUFFLER START LEVER
BUTTON
RECOIL
,(AUXILIARY) TRACTION
CHOKE STARTER CHUTE DRIVE
CONTROL HANDLE DEFLECTOR CONTROL
ON / OFF LEVER
SWITCH
PRIMER
SAFETY
IGNiTiON
KEY
=H TURN
TRIGGER
NOTE: iTEMS ABOVE
ARE SHOWN iN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY
VARY WiTH THE
ENGINE ON YOUR
UNIT.
THROTTLE DISCHARGE
CHUTE
CLEAN=OUT
TOOL
HANDLE
KNOB
MUFFLER
TOOLBOX
PLATE
AUGERS
FiG. 10
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox = used to store spare shear bolts, Iocknuts and
wrench.
Safety ignition key =must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for starting the
engine.
LH and RHturn triggers =used to steer the snow thrower.
Drive speed control lever = used to select forward or
reverse motion and speed of snow thrower.
Primer = pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
ON / OFF switch - used to STOP the engine.
10
Choke control - used for starting a cold engine.
Throttle/engine control - used to select either FAST or
SLOW engine speed and to STOP the engine.
Traction drive control lever - used to engage power-pro-
pelled forward or reverse motion of snow thrower.
Auger control lever - used to engage auger motion (throw
snow).
Deflector remote control lever = used to change the
distance the snow isthrown.
Discharge chute control lever = used to change the di-
rection the snow is thrown.
Skid plate = used to adjust height of scraper bar from the
ground.