Filter
Top Products
Tools Required for Assembly
Adjustablewrench
Allenwrench 5ram (included)
Remove Pressure Washer from Carton
• Open box from the top. Locate and remove from
box, the parts box, which includes gun, handle,
wand,oil, knobs and J bolts. Next remove the parts
bag and the handle.
• Cut carton along dotted lines.
• Remove all carton inserts.
• Roll unit through opening in Carton,
NOTE: The hose is located at the bottom of the box,
Preparing the Pressure Washer for First Use
Note: Included with your pressure washer is a
video cassette tape on how to prepare your unit
for operation. It is recommended you view this
tape before performing the next steps,
1. • Insert handle onto frame.
• Slide J bolts into frame.
• Tighten knobs turning in clockwise direction.
!ir lghten knob in clockwise
ctinn to threaded end of J bob+)
(inzert J bolt Itere, Th,,,_zdedend
_9oes in bOt_m hole)
2. =Using an adjustable wrench, remove nut from bolt
that attaches board to frame. Remove wood plank
from the frame of the unit. Discard bolt and board.
3. • Mount the rubber isolator to the frame. To mount
isolator place threaded end of bolt through the
washer. Next with washer on boIt place threaded
end of bolt through the larger holein bottom of the
rubber isolator. Place threaded portion of bolt
through the same hole location the wood plank
was mounted to on the pressure washer. Next
place the tee nut over the threaded portion of the
bolt and use the allen wrench provided to tighten
isolator to the frame.
PRESSURE TEE NUT
WASHe. I
L J
-- ISOLATOR
4. • Connect wand extension to gun. To tighten, turn
knob in clockwise direction. Hand tighten.
5. =Remove tie wrap off of high pressure hose.
Unwind high pressure hose and attach the
threaded end to the gun.
6. • Connect high pressure hose to outlet on pressure
washer and hand tighten firmly. Connect
chemical pickup hose to hose barb on pump.
CHEMICAL-'--'---_k-_ II HOSE
NOTE: Always keep hose away from engine muffler.
6