Filter
Top Products
TO REMOVE WHEEL FOR REPAIRS
FRONT WHEEL (See Fig°29)
° Block up axle securely_
o Remove axle cover, retaining ring and washersto ailow
wheel removal.
° Repair tire and reassemble.
o Replace washers and snap retaining ring securely in
axle groove.
• Replace axle cover.
WASHERS
RETAINING
AXLE
COVER
FIG. 29
"POSITIVE" (+) "NEGATIVE" [-)
L.H.
PANEL
BOLT
FIG. 30
REAR WHEEL -
,, Block rear axle securely.
° Remove five (5) hub bolts to allow wheel removal.
° Repair tire and reassemble. Replace and tighten hub
bolts securely.
TO START ENGINE WITH A WEAK BATTERY
(See Fig. 30)
CAUTION: Lead-acid batteries gener_...........t
ateexplosive gases. Keepsparks, flame
and smoking materials away from bat- I
teries. Always wear eye protection |
when around batteries.
II
if your battery is too weak to start the engine, it should be
recharged° If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT: YOUR TRACTOR tSEQUIPPED WiTH A 12
VOLT NEGATIVE GROUNDED SYSTEM THE OTHER
VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE
GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR
BATTERY TO START OTHER VEHICLES
TO ATTACH JUMPER CABLES -
° Connect each end of the RED cable to the POSITIVE
(+) terminal of each battery, taking care not to short
against chassis,.
• Connect one end of the BLACK cable to the NEGA-
TIVE (_)terminal of fully charged battery,
° Connect the other end of the BLACK cable to a panel
bolt on the left side of the tractor,away from fuel tank
and battery
TO REMOVE CABLES, REVERSE ORDER -
° BLACK cable first from chassis and fully charged
battery.
, RED cable last from both batteries,.
TO REPLACE HEADLIGHT BULB
° Raise hoo&
° Pul! bulb holder out of the hole in the backside of the
grill.
° Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
° Checkwiring_ See electrical wiring diagram in Repair
Parts section of this manual.
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in fuse, The
fuse holder is located behind the dash.
23