OPERATION
.................................. iiiii iiii iii1,11i,,i,
, ,, , ,,,,,, ,,,, ,,, ,,,,,,,,,,,,,,, ,liliiH
The operation ofany tractor can result inforeign objects thrown into the eyes, which can result
in severe eye damage. Always wear safety glasses or eye shields while operating your tractor
or performing any adjustments or repairs. We recommend a wide vision safety mask over the
spectacles or standard safety glasses.
iiiiii ..............................................
HOW TO USE YOUR TRACTOR
TO SET PARKING BRAKE (See Fig. 6)
Your'tractor isequipped withan operator presence sensing
switch. When engine is running, any attempt by the
operator to leavethe seat without first setting the parking
brake will shut off the engine.
• Depress clutch/brake pedal into full "BRAKE" position
and hold_
• Place parking brake lever in"ENGAGED" position and
release pressure from clutch/brake pedal,, Pedalshould
remain in"BRAKE" position,, Make sure parking brake
will hold tractor secure_
ATTACHMENT
IGNITION CLUTCH SWITCH
KEY -- USH IN TO PULL OUT TO
P_.......... "ENGAGE"
CHOKE "\ _._-,-,,--_ ",,, /
CONTROL ._ .'_V_-_f-.._"-_ \ _..L
"BRAKE" :-V "-J
PARKING
POSITION -.... _ _-----'-'_ _
\ _ _,_ BRAKE "ENGAGED"
\ l_ J F_L')J_T-_--_PosrnoN
"_\/ '.".. _ -J/ "" I \ _, SHIFT
,.% / ......!........ \ LEVER
/ "DISENGAGED" \
CLUTCH/ / POSITION GEARSHIFT
BRAKE HEIGHT LEVER
PEDAL ADJUSTMENT
"DRIVE" KNOB
POSITION
FIG. 6
STOPPING (See Fig. 6)
MOWER BLADES -
• Move attachment clutch switch to "DISENGAGED"
position,,
GROUND DRIVE -
• Depress clutch/brake pedat into full "BRAKE" position.
° Move gearshift lever to neutral iN) position.
ENGINE -
• Move throttle control to slow (,,J_) position.
NOTE: Failure to move throttle control to slow (.,m_)
position arid allowing engine to idle before stopping may
cause engine to "backfire".
• Turn ignition key to "OFF" position and remove key.
Always remove key when leaving tractor to prevent
unauthorized use,.
° Never use choke to stop engine,.
NOTE: Under certain conditions when tractoris standing
idlewiththe engine_nning, hotengine exhaustgases may
cause "browning" of grass. To eliminate this possibility,
always stop enginewhen stopping tractoron grass areas.
CAUTION: Always stop tractor com-
pletely,asdescribed above, before leav-
ing the operator's position; to empty
grass catcher, etc.
TO USE THROTTLE CONTROL (See Fig. 6)
Always operate engine at full throttle_
° Operating engineat less than full throttle reduces the
battery chargingrate°
• Full throttleoffersthe best mower performance_
TO USE CHOKE CONTROL (See Fig. 6)
Use chokecontrolwhenever youare startinga coldengine.
Do not use to start a warm engine_
° To engage choke control,pull knob ouL Slowly push
knob in todisengage.
TO MOVE FORWARD AND BACKWARD
(See Fig. 6)
The directionand speed of movement iscontrolledby the
geat'shift lever.
° Start tractor' with clutch/brake pedal depressed and
gearshift lever in neutral iN) position.
- Move gearshift and range shift levers to desired posi-
tion.
• Slowly release clutch/brake pedal to start movement.
IMPORTANT: BRING TRACTOR TO A COMPLETE STOP
BEFORE SHIFTING OR CHANGING GEARS. FAILURE
TO DO SO WILL SHORTEN THE USEFUL LIFE OF YOUR
TRANSAXLE.
TO ADJUST MOWER CUTTING HEIGHT (See
Fig. 6)
The cutting height iscontrolled byturning the height adjust-
ment knob in desired direction.
• Turn knob clockwise (("_) to raise cutting height.
- Turn knob counterclockwise (1_'_)to lower cutting
height.
The cutting height range is approximately 1-1/2" to 4-1/2",
The heights are measured from the ground to tile blade tip
with the engine not running. These heights are approxi-
mate and may vary depending upon soil conditions, height
of grass and types of grass being mowed,.
• The average lawn should be cutt=t.J.g.approximately2-1/2
inches during the cool_d'_ and to over 3 inches
during hot months, For healthier and better looking
lawns, mow often and after moderate growth_
• For best cutting performance, grass over 6 inches in
height should be mowed twice. Make the first cut
relativelyhigh; the second to desired height.
12