Filter
Top Products
H", HIH ='H= H ,','HN"= I
CONNECT SHIFT RO D (See Fig. 6)
o insert end of shift rod farthest from bend into hole of
shift lever indicator,
o Insert hairpin clip through hole of shift rod to secure.
o Insert other end of shift rod into hole in shift lever_
° Insert second hairpin clip through hole of shift rod,
ATTACH THIS END ATTACH THIS
TO SHIFT LEVER END TO SHIFT
INDICATOR LEVER _
,i
! '_ .....
SHIFT ROD
SHIFT
HAIRPIN
SHIFT
LEVER
INDICATOR
SHIFT LEVER ,_
HAIRPIN CLIP
SHIFT ROD
FIG. 6
REMOVE TILLER FROM CRATE
- Make sure shift lever indicator is in "N" (neutral) posi-
tion (See Fig° 6)
= Tilt tiller forward by lifting handle, Separate cardboard
cover from leveling shield,.
= Rotate tiller' handle to the right and pull tiller out of
carton.
INSERT CABLE CLIP (See Fig. 7)
o Insert plastic cable ciip into hole on the back of handle
column,. Push cables into clip.
HANDLE
COLUMN
\
CABLES
CLIP
FIG. 7
CHECK TIRE PRESSURE
The tires on your unit were overinflated at the factory for
shipping purposes. Correct and equa} tire pressure is
important for best tilling performance.
, Reduce tire pressure to 20 PSL
HANDLE HEIGHT
= Hand!e height may be adjusted to better suit operator°
(See q'O ADJUST HANDLE HEIGHT" in the Service
and Adjustments section of this manual),.