Filter
Top Products
i, ,, i i ................................................
,i i, ,
ASS LY
Your new tiller has been assembled at the factory with exception of those parts left unassembted for=shipping purposes. To
ensure safe and proper operation of your' tiller all parts and hardware you assemble must be tightened securely° Use the
correct tools as necessary to insure proper tightness,
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier= Standard
wrench sizes are listed_
(1) Utility knife
(1) Wire cutter
(1) Screwdriver
(1) Tire pressure gauge
(1) Pair'of pliers
(1) 9/16" wrench
OPERATOR'S POSITION (See Fig. 1)
When right or left hand is mentioned in this manual, it
means when you are in the operating position (standing
behind tiller handles).=
FRONT
LEFT
RIGHT
OPERATOR'S
POSITION
FIG. 1
CONTENTS OF HARDWARE PACK
(2) Handle Locks
(!) Flat Washer 13132x 1 x 11 Ga.
(2) Carriage Bolts 3/8-16 UNC x I GL 5 (2) Center Locknuts 3/8-16 UNC
©
(1) Handle Lock Lever
(2) Hairpin Clips
(1) Cable Clip
(1) Manual