Filter
Top Products
Theoperationofanytillercanresultinforeignobjectsthrownintotheeyes,
whichcanresultin severeeye damage. Always wear safety glasses or eye
shields before starting your tiller and while tilling. We recommend a wide vision
safety mask over spectacles or standard safety glasses•
HOW TO USE YOUR TILLER
Know how to operate all controls before
adding fuel and oil or attempting to start
engine.
STOPPING
TINES
• Release forward tine control to stop for-
ward movement•
• Release reverse tine control to stop
reverse movement.
ENGINE
• Move throttle control to "STOP" position.
• Never use choke to stop engine.
Reverse "RneControl
Forward "fineControl
=OFF _Position
forward "l]neControl
=ON"(DOWN) PosiUon
The depth stake should always be below
the wheels for digging. It serves as a
brake to slow the tillers forward motion to
enable the tines to penetrate the ground.
Also, the more the depth stake is lowered
into the ground the deeper the tines will
dig.
DEPTH STAKE
Adjust depth stake by removing the hair-
pin clip and clevis pin. Change depth
stake to desired position. Replace the cle-
vis pin and hairpin clip.
• For normal tilling, set depth stake at the
second or third hole from the top.
WHEELS
Adjust wheels by removing the hairpin clip
and clevis pin. Change wheel position.
Replace the hairpin clip and clevis pin.
• For normal tilling, set wheels at the sec-
ond or third hole from the top•
Hairpin Clip
and Clevis Pin
Throttle
"Choke
Control
Depth Stake
Hairpin Clip
and Clevis Pin
TINE OPERATION
FORWARD
• Squeeze forward tine control to handle.
REVERSE
• With forward tine control in =OFF" (up)
position, pull back and hold reverse tine
control.
TILLING
The speed and depth of tilling is regulated
by the position of the depth stake and
wheel height•
8
TRANSPORTING YOUR TILLER
_,CAUTION: Before lifting or transport-
ing, allow tiller engine and muffler to cool.
Disconnect spark plug wire. Drain gaso-
line from fuel tank.
AROUND THE YARD
• "lip depth stake forward until it is held by
the stake spring.
• Push tiller handles down, raising tines
oft the ground.
• Push or pull tiller to desired location.
AROUND. TOWN
• Disconnect spark plug wire.
• Drain fuel tank.
• Transport in upright position to prevent
oil leakage. _ -