Filter
Top Products
" Tilttillerbackonits whe_lsandthenre-
level
o Withenginelevel,refillto pointof over-
flowingif necessary.Replaceoilfiller
plug.
o Forcoldweatheroperationyoushould
changeoil foreasierstarting(See "OIL
VISCOSITYCHART intheCustomer
Responsibilitiessectionof thismanual).
o Tochangeengineoil,seethe Customer
Responsibilitiessectionof thismanual°
OilLevel.
Filler
Plug
ADD GASOLINE
= Fill fuel tank. Use fresh, clean, regular
unleaded gasoline. (Use of leaded
gasoline will increase carbon and lead
oxide deposits and reduce valve life.)
IMPORTANT: When operating in
Temperatures below 32°F (0°C), use fresh,
clean, winter grade gasoline to help insure
good cold weather starting_
WARNING: Experience indicates that
alcohol blended fuels (called gasohol or
using ethanol or methanol) can attract
moisture which leads to separation and
formation of acids during storage. Acidic
gas can damage the fuel system of an
engine while in storage. To avoid engine
problems, the fuel system should be emp-
tied before storage of 30 days or longer.
Drain the gas tank, start the engine and let
it run until the fuel lines and carburetor are
empty Use fresh fuel next season. See
Storage section of this manual for addition-
al information. Never use engine or carbu-
retor cleaner products in the fuel tank or
permanent damage may occur
,_CAUTION: Fil! to within t/2 inch of top
of fuel tank to prevent spills and to allow
for fuel expansion. If gasoline is acciden-
tally spilled, move machine away from
area of spill, Avoid creating any source of
ignition until gasoline vapors have disap-
peared. Do not overfill. Wipe off any
spilled oil or fuel. Do not store, spill or use
gasoline near an open flame.
9
_ START ENGINE
CAUTION: Keep tine control in "OFF"
position when starting engine°
When starting engine for the first time or if
engine has run out of fuel, it will take extra
pulls of the recoil starter to move fuel from
the tank to the engine.
o Make sure spark plug wire is properly
connecte&
• Place throttle control in "FAST' position.
• Move choke control to full "CHOKE"
position, Grasp recoil starter handle with
one hand and grasp tiller handle with
other hand Pull rope out slowly until
engine reaches start of compression
cycle (rope will pull slightly harder at this
point).
o Pull recoil starter handle quickly. Do not
let starter handle snap back against
starter. Repeat if necessary.
• If engine fires but does net start, move
choke control to half choke position. Pull
recoil starter handle until engine starts.
° When engine starts, slowly move choke
control to "RUN" position as engine
warms up.
NOTE: A warm engine requires less chok-
ing to start.
o Move throttle control to desired running
position.
o Allow engine to warm up for a few min-
utes before engaging tine&
NOTE: If at a high altitude (3000 feet) or
in cold temperatures (below 32°F), the car-
buretor fuel mixture may need to be
adjusted for best engine performance.
See "TO ADJUST CARBURETOR" in the
Service and Adjustments section of this
manual.
NOTE: If engine does not start, see trou-
bleshooting points,
Plug
Control
. Recoil Starter
BREAKING IN YOUR TILLER
Break-in your belt(s), pulleys and tine con-
trol before you actually begin tilling