Filter
Top Products
UNPACK CARTON & INSTALL HAN-
DLE
_CAUTION: Be careful of exposed sta-
ples when handling or disposing of carton-
ing material.
IMPORTANT:: When uNpacking and as-
sembling tiller, be careful not to stretch or
kinK cable(s).
= Cut cable ties securing handles.
o The handle may be assembled in high
or low position,, Slowly lift handle as-
sembly up and align handle holes with
desired handle panel hole and slot.
= Loosely assemble hardware as shown.
Be sure the "
shorter (3/4" long) hex bolt is assembled
in lower hole of handle, Repeat for
opposite side. Tighten all hardware se-
curely.
o Cut cable ties securing tiller to skid and
remove tiller from skid,
Handle Panel _ ..Lock Washer
v I-rex_ol[s-" 5/16-18 x 1
5/16-18 x 3/4"
Hex Bolt_
Engine Bracket Halves
Nut "A"
/
Depth Stake
Support
_X Stake
b/ Support Bolt
Stake Spring
Lockwashers, and Hex nuts
HANDLE HEIGHT
o Handle height may be adjusted to better
suit operator: (See "HANDLE HEIGHT"
in the Service and Adjustments section
of this manual).
TILLING WIDTH
= Tilling Width may be adjusted to better
handle your tilling conditions (See "TINE
ARRANGEMENT' in the Service and
Adjustments section of this manual)°
TINE OPERATION
o Check tine operation before first use,
(See 'q'INE OPERATION CHECK" in the
Service and Adjustments section of this
manual),
Handle
Panel Bolts
INSTALL DEPTH STAKE ASSEMBLY
o Loosen nut "A".
o Insert stake support between engine
bracket halves with stake spring down,
o Bolt stake support to engine brackets
with bolts, lock washers and nuts.
Tighten securely, Tighten nut "A",
• Depth stake must move freely. If it does
not, loosen support bolt.
6