Filter
Top Products
Immediatelyprepareyourtillerfor storage
attheendof theseasonor iftheunitwill
notbeusedfor 30daysor more,,
,_kCAUTION: Never' store the tiller with
gasoline in the tank inside a building
where fumes may reach an open flame or
spark. Allow the engine to cool before
storing in any enclosure,
TILLER
o Clean entire tiller (See "CLEANING" in
the Customer Responsibilities section of
this manual).
o Inspect and replace belts, if necessary
(See belt replacement instructions in the
Service and Adjustments section of this
manual)_
. Lubricate as shown in the Customer
Responsibilities section of this manual.
o Be sure that all nuts, bolts and screws
are securely fastened_ Inspect moving
parts for damage, breakage and wear:,
Replace if necessary.
o ]buch up all rusted or chipped paint sur-
faces; sand lightly before painting,.
ENGINE
FUEL SYSTEM
IMPORTANT: It is important to prevent
gum deposits from forrning in essential fuel
system parts such as the carburetor, fuel
filter, fuel hose, or tank during storage_
also, experience indicates that alcohol
blended fuels (called gasohol or using
ethanol or methanol) can attract moisture
which leads to separation and formation of
acids during storage. Acidic gas can dam-
age the fuel system of an engine while in
storage.
o Drain the fuel tank.
o Start the engine and let it run until the
fuel lines and carburetor are empty=
,, Never use engine or carburetor cleaner
products in the fuel tank or permanent
damage may occur.
o Use fresh fuel next season.
NOTE: Fuel stabilizer is an acceptable
alternative in minimizing the formation of
fuel gum deposits during storage. Add sta-
bilizer to gasoline in fuel tank or storage
container. Always follow the mix ratio
found on stabilizer container: Run engine
at least 10 minutes after adding stabilizer
to allow the stabilizer to reach the carbure-
tor. Do not drain the gas tank and carbu-
retor if using fuel stabilizer.
ENGINE OIL
Drain oil (with engine warm) and replace
with clean oilo (See "ENGINE" in the
Customer Responsibilities section of this
manual)°
CYLINDERS
• Remove spark plug
° Pour 1 ounce (29 ml) of oil through
spark plug hole into cylinder,
. Pull starter handle slowly several times
to distribute oilo
° Replace with new spark plug.
OTHER
o Do not store gasoline from one season
to another:
• ReplaCe your gasoline carl if your can
starts to rust. Rust and/or dirt in your
gasoline will cause problems.
o If possible, stere your unit indoors and
cover it to give protection from dust and
dirt.
o Cover your unit with a suitable protective
cover that does not retain moisture. Do
not use plastic. Plastic cannot breathe
which allows condensation to form and
will cause your unit to rust,
IMPORTANT: Never cover tiller while
engine and exhaust areas are still warm,
I 16