Filter
Top Products
Sleeves
Jam Nuts
TO REMOVE WHEEL FOR REPAIRS
FRONT WHEEL
• Block up axle securely.
• Remove axle cover, retaining ring and
washers to allow wheel removal.
Repair tire and reassemble.
Replace washers and snap retaining
nng securely in axle groove.
• Replace axle cover.
REAR WHEEL -
Block rear axle securely.
Remove five (5) hub bolts to allow
wheel removal.
• Repair tire and reassemble. Replace
and t=ghtenhub boltssecurely.
NOTE: To seal tire punctures and prevent
flat tirosdue to slow leaks, bre sealant
may be purchased from your local parts
dealer. Tire sealant also prevents tire dry
rot and corrosion.
Washers
Rs n,ng
Ring
TO START ENGINE WITH A WEAK
BATTERY
_,CAUTION: Lead-acid batteries gener-
ate explosive gases. Keep sparks, flame
and smoking materials away from batter-
ies. Always wear eye protection when
around batteries.
If your battery is too weak to start the
_ngine, it should be recharged. (See
'BATrERY" in the MAINTENANCE sec-
:ion ofthis manual).
f "jumper cables" are used for emergency
;tatting;,follow this procedure:
MPORTANT: Your tractor Is equipped
_ith a 12 volt negative grounded system.
The other vehical must also be a 12 volt
negative grounded system. Do not use
your tractor battery to start other vehicles.
28
TO ATTACH JUMPER CABLES -
• Connect each end of the RED cable to
the POSITIVE (+) terminal of each bat-
tery, taking care not to short against
chassis.
• Connect one end of the BLACK cable to
the NEGATIVE (-) terminal of fully
charged battery.
• Connect the other end ofthe BLACK
cable to good CHASSIS GROUND,
away from fuel tank and battery.
TO REMOVE CABLES, REVERSE
ORDER -
• BLACK cable first from chassis and
then from the fully charged battery.
• RED cable last from both batteries.
"Positive"(+) =Negative" (-)
L.H. Panel I-_611
Bolt _
REPLACING BATFERY
ACAUTION: Do not short battery termi-
nals by allowing a wrench or any other
object to contact both terminals at the
same time. Before connecting battery,
remove metal bracelets, wristwatch
bands,rings,etc.
Positiveterminal must be connected first
to prevent sparking from accidental
grounding.
• Lifthoodto raised position.
• Remove terminal guard.
• Disconnect BLACK battery cable then
RED battery cable and carefully remove
battery from tractor.
• Install new battery with terminals in
same positionas old battery.
• Reinstallterminal guard.
• Firstconnect RED battery cable to peal-
five (+) battery terminal with hex bolt,
keps nut as shown. Tighten securely.
• Connect BLACK grounding cable to
negative (-) battery terminal with
remaining hex bolt, keps nut. Tighten
securely.
Close terminal access doors.
Close hoo.d.