Filter
Top Products
LeftHand
Mandrel
Mower Blade
Ddve Belt
Center
Mandrel
Right Hand
Cover
Screw
IdlerArm
Spdng
Anit-Sway Bar Idler
Bracket
Pulley
TO ADJUST ATTACHMENT CLUTCH
The electric clutch should provide years of
service. The clutch has a built-in brake
that stops the pulley within 5 seconds.
Eventually, the intemal brake will wear
which may cause the mower blades to not
engage, or, to not stop as required.
Adjustments should be made by your
nearest authonzed service center/depart-
ment.
• Make sure attachment clutch and igni-
tion switches are in =OFF" position.
• Adjust the three nylon Iocknuts until
space between clutch plate and rotor
measures .012" at all three slot loca-
tions cut in the side of brake plate.
Rotor.,_,. ClutchtPlat_e
./I/\
Nylon Locknut(3F Brake Plate
NOTE: After installing a new electdc
clutch, m9 tractor at full throttle and
engage and disengage electric clutch 10
cycles to wear in clutch plate._
TO ADJUST BRAKE
Your tractor is equipped with an adjustable
brake system which is mounted on the
side of the transaxle.
If tractor requires more than six (6) feet
stopping distance at high speed in high-
est gear, then brake must be adjusted.
• Depress clutch/brake pedal and engage
parking brake.
• Measure distance between brake oper-
ating arm and nut "A" on brake rod.
• If distance is other than 1-1/2", loosen
jam-nut and tum nut =A" until distance
becomes 1-1/2". Retighten jam nut
: against nut =A".
26
., Road test tractor for proper stopping
distance as stated above. Readjust if
necessary. If stopping distance is still
greater than six (6) feet in highest gear,
further maintenance is necessary.
Contact your nearest authorizedser-
vice center/department.
With Parking Brake "Engaged"
Nut "A"
Jam Nut
3peraSng
Arm
TO REPLACE MOTION DRIVE BELT
Park the tractoron level surface. Engage
parkingbrake. For ease of service there
is a belt installationguide decal on bottom
of left footrest.
• Remove mower (See "TO REMOVE
MOWER" in this section of this manual.)
BELT REMOVAL -
• Engage parking brake (creates slack in
belt).
• Remove belt from clutching and fan
idler pulleys.
• Loosen belt keeper above transaxle pul-
ley.
• Remove belt from transaxle pulley.
• Remove belt from engine pulley and
front V-idler pulley.
• Pull belt out of all belt keepers and
remove from tractor.