Filter
Top Products
Battery
Door
INSTALL SEAT
Adjust seat before tightening adjustment
knob.
1. Remove adjustment knob and flat
washer securing seat to cardboard
packing and set aside for assembly of
seat totractor.
2. Pivot seat upward and remove from
the cardboard packing. Remove the
cardboard packing and discard.
3. Place seat on seat pan so head of
shoulder bolt is positioned over large
slotted hole in pan.
4. Push down on seat to engage
shoulder bolt in slot and pull seat
towards rear of tractor.
5. Pivot seat and pan forward and
assemble adjustment knob and flat
washer loosely, Do not tighten,
6. Lower seat into operating position and
sit in seat.
7. Slide seat until a comfortable position
is reached which allows you to press
clutch/brake pedal all the way down.
8. Get off seat withoutmoving its
adjusted position.
9. Raise seat and tighten adjustment
knob securely.
Seat
Seat Pan-_
Belt
FlatW__
NOTE: You may now roll or drive your
tractor off the skid. Follow the appropriate
instruction below to remove the tractor
from the skid,
TO ROLLTRACTOR OFF SKID (See
Operation section for location and
function of controls)
1. Press lift lever plunger and raise
attachment lift leverto its highest
position.
2. Release parking brake by depressing
clutch/brake pedal.
3. Place freewheel control in freewheel-
ing position to disengage transmission
(See "TO TRANSPORT" in the
Operation section of this manual).
4. Roll tractorforward off skid.
5. Remove banding holding deflector
shield up against tractor.
TO DRIVETRACTOR OFF SKID (See
Operation section for location and
function of controls)
_ILWARNING: Before starting, read,
understand and follow all instructionsin
the Operation sectionof thismanual. Be
sure tractor is in a well-ventilated area. Be
sure the area in front of tractor is clear of
other people and objects.
1. Be sure all the above assembly steps
have been completed.
2. Check engine oil level and till fuel tank
with gasoline.
3. Place freewheel control in "transmis-
sion engaged" position,
4. Sit on seat in operating position,
depress clutch/brake pedal and set the
parking brake.
5. Place motioncontrol lever in neutral
(N) position.
6. Press lift lever plungerand raise
attachment lift lever to its highest
position.
7, Start the engine. After engine has
started, move throttle control to idle
position.
8. Release parking brake,
9. Slowly move the motion control lever
forward and slowly drive tractor off
skid.
1O.Apply brake to stop tractor, set parking
brake and place motion control lever
in neutral position.
11.Turn ignition key to "OFF" position,
Continue with the instructions that follow.