Filter
Top Products
TO A'I-FACHJUMPER CABLES -
1. Connect each end of the RED cable
to the POSITIVE (+) terminal of each
battery, taking care not to short
against chassis.
2. Connect one end of the BLACK cable
to the NEGATIVE (-) terminal of fully
charged battery.
3. Connect the other end of the BLACK
cable to good CHASSIS GROUND,
away from fuel tank and battery.
TO REMOVE CABLES,REVERSE
ORDER -
1. BLACK cable first from chassis and
then from the fully charged battery.
2. RED cable last from bothbatteries.
PositiveTerminal NegativeTerminal
Charged
Battery
PositiveTerminal
Negative Terminal
_.EPLACING BATTERY
CAUTION: Do not short battery
terminals by allowing a wrench or any
other object to contact bothterminals at
the same time. Before connecting battery,
remove metal bracelets, wristwatch
bands, rings, etc.
Positive terminal must be connected fimt
to prevent sparking from accidental
grounding.
1. Lift seat pan to raised position and
open battery box door.
2, Disconnect BLACK battery cable first
then RED battery cable and carefully
remove battery from tractor.
3. Install new battery with terminals in
same position as old battery.
4. First connect RED battery cable to
positive (+) terminal with hex bolt and
keps nut as shown. Tighten securely.
5. Connect BLACK grounding cable to
negative (-) terminal with remaining
hex bolt and keps nut. Tighten
securely.
6. Close battery box door.
Battery
Box
Keps
Nut "_# Hex
B_t
Positive (Red) Cable Black)
Cable
TO REPLACE HEADLIGHT BULB
1. Raise hood.
2. Pull bulb holder out of the hole in the
backside of the grill
3. Replace bulb in holder and push bulb
holder securely back into the hole in
the backside of the griJL
4. Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiringmay cause your
tractorto runpoorly,stoprunning, or
preventitfrom starting,
• Check wiring. See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 20 amp automotive-type
plug-infuse. The fuse holder islocated
behind the dash,
TO REMOVE HOOD AND GRILL AS-
SEMBLY
1. Raise hood.
2. Unsnap headlight wire connector.
3. Stand infront of tractor. Grasp hoodat
sides, tilttoward engine and liftoff of
tractor.
4. To replace, reverse above procedure.
+ H
\\_ , _.. ood
!' /] I HeadlightWire
_ J Connector
26