Filter
Top Products
WeldNutFmrn._---_.
_. - "-7 "_ Hook Points
me Iop_/ _ Down
Lock ¥
Weld Washer _'_'|
Nut . !
• . h _,_ // /I , _ Latch
LaTc ._ _,.U/ //I J _H k
Was o, 7J Loc.W ,her
Mulcher .====_,_Screw Washer
Plate _
Deflector.__
Shleld_,_,,,
_" --_._/,_/_ Latch
\'*_=__ Hooks
j,,
CHECK TIRE PRESSURE
The tires on your tractor were overinflated
at the factory for shipping purposes.
Correct fire pressure is important for best
cutting performance.
• Reduce tire pressure to PSI shown in
"PRODUCT SPECIFICATIONS" section
of this manual.
CHECK DECK LEVELNESS
For best cutting results, mower housing
should be propedy leveled. See "TO
LEVEL MOWER HOUSING" in the
Service and Adjustments section of this
manual.
CHECK FOR PROPER POSITION OF
ALL BELTS
See the figures that are shown for replac-
ing moron and mower blade drive belts in
the Service and Adjustments section of
this manual. Verify that th_ebelts are rout-
ed correctly.
CHECK BRAKE SYSTEM
After you learn how to operate your trac-
tor, check to see that the brake (s properly
adjusted. See =TO ADJUST BRAKE" in
the Service and Adjustments section of
this manual.
#CHECKLIST
PLEASE REVIEW THE FOLLOWING
CHECKLIST:
,/ All assembly instructions have been
completed.
# No remaining loose parts in carton.
# Battery is properly prepared and
charged. (Minimum 1 hour at 6 amps).
•/ Seat is adjusted comfortably and
tightened securely.
# All tires are propedy inflated. (For
shipping purposes, the tires were
ovednflated at the factory).
,/ Be sure mower deck is properly leveled
side-to-side/front-to-rear for best
cutting results. (]ires must be prepedy
inflated for leveling).
,/ Check mower and drive belts. Be sure
they are routed properly around pulleys
and inside all belt keepers.
,/ Check wiring. See that all connections
are still secure and wires are properly
clamped.
WHILE LEARNING HOW TO USE YOUR
TRACTOR, PAY EXTRAATTENTION TO
THE FOLLOWING IMPORTANT ITEMS:
,/ Engine oil is at proper level.
•/ Fuel tank is filled with fresh, clean,
regular unleaded gasoline.
# Become familiar with all controls - their
location and function. Operate them
before you start the engine.
#' Be sure brake system is in safe
operating condition.
10