Filter
Top Products
TO REPLACE HEADLIGHT BULB
o Raise hood.
o Pul! bulb holder out of the hole in the
backside of the grill
o Replace bulb in holder and push bulb
holder securely back into the hole in the
backside of the grill°
o Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or pre-
vent it from starting.
o Check wiring. See electrical wiring dia-
gram in the Repair Parts section of this
manual
TO REPLACE FUSE
Replace with 30 amp automotiveotype
plug-in fuse° The fuse holder is located
behind the dash.
TO REMOVE HOOD AND GRILL
ASSEMBLY
• Raise hood.
o Unsnap headlight wire connector.
o Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
o To replace, reverse above procedures_
Hood
ENGUNE
Maintenance, repair, or replacement of the
emission control devices and systems,
which are being done at the customers
expense, may be performed by any non-
road engine repair establishment or indi-
vidual. Warranty repairs must be per-
formed by an authorized engine manufac-
turer's service outteL
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at the
factory and adjustment should not be nec_
essary. Check adjustment as described
below before loosening cable, if adjust-
ment is necessary, proceed as follows:
o With engine not running, move throttle
control lever from stow to choke posi-
tiono Slowly move lever from choke to
fast position.
° Check that holes "A" in governor control
lever and hole in governor plate line-up.
If holes "A" are not aligned, loosen
clamp screw and move throttle cable
until holes are aligned. Tighten clamp
screw securely.
Governor
Control Plate
Governor
Control Lever
\
Headlight
Wire
Connector
Holes "A"
Clamp
Screw
Throttle
Cable
25