Filter
Top Products
TO ADJUST STEERING WHEEL ALIGN-
MENT
If steering wheel crossbars are not hod-
zontal (left to right) when wheels are posi-
tioned straight forward, remove steering
wheel and reassemble per instructions in
the Assembly section of this manual.
FRONT WHEEL TOE-IN/CAMBER
The front wheel toe-in and camber are not
adjustable on your tractor: If damage has
occurred to affect the front wheel toe-in or
camber', contact your nearest authorized
service center:
TO REMOVE WHEEL FOR REPAHRS
o Block up axle securely.
o Remove axle cover, retaining ring and
washers to allow wheel removal (rear
wheel contains a square key - Do not
Iose)o
o Repair tire and reassemble.
o On rear wheels only: align grooves in
rear wheel hub and axle. Insert square
key.
o Replace washers and snap retaining
ring securely in axle groove.
o Replace axle cover.
NOTE: To seal tire punctures and prevent
flat tires due to slow leaks, tire sealant
may be purchased from your local parts
dealer. Tire sealant also prevents tire dry
rot and corrosion.
Washers
The other vehicle must also be a 12 volt
negative grounded system. Do not use
your tractor battery to start other vehicles.
TO ATTACH JUMPER CABLES
o Connect each end of the RED cable to
the POSITIVE (+)terminal of each bat-
tery, taking care not to short against
chassis.
o Connect one end of the BLACK cable to
the NEGATIVE (-) terminal of fully
charged battery.
o Connect the other end of the BLACK
cable to good CHASSIS GROUND,
away from fuel tank and battery_
TO REMOVE CABLES, REVERSE
ORDER
o Remove BLACK cable first from chassis
and then from the fully charged battery°
o Remove RED cable last from both bat-
teries_
Positive Terminal Negative Terminal
Retaining
Ring
Axle Cover
!
'_ Square Key
(Rear Wheel Only)
TO START ENGINE THAT HAS A WEAK
BATTERY
_kCAUTmON: Lead-acid batteries gener-
ate explosive gases_ Keep sparks, flame
and smoking materials away from batter-
ies. Always wear eye protection when
around batteries.
if your battery is too weak to start the
engine, it should be recharged_ If "jumper
cables" are used for emergency starting,
follow this procedure:
IMPORTANT: '(our tractor is equipped
with a 12 volt negative grounded system.
Positive Terminal
24
Charged
Battery
Negative Terminal