Filter
Top Products
CUSTO RESPONSIBILITIES
AIR FILTER (See Fig. 16)
Your engine wilt not run properly using a dirty air filter,.
Clean the foam pre-cleaner after every 25 hours of opera-
tion or every season, Service paper cartridge every t00
hours of operation or every season, whichever occurs first.
Service air cleaner more often under dusty conditions,
. Remove knob and cover_
o Remove wing nut and air cleaner from base.
TO SERVICE PRE-CLEANER
. Slide foam pre-cleaner off cartridge..
= Wash it in liquid detergent and water.
o Squeeze it dry in a clean cloth. Allow itto dry.
o Saturate it in engine oil, Wrap it in ctean, absorbent
cloth and squeeze to remove excess oil.
TO SERVICE CARTRIDGE
• Replace a dirty, bent, or damaged cartridge,
NOTE: Do not wash the paper cartridge or use pressurized
air, as this will damage the cartridge..
,, Reinstall the pre-cleaner (cleaned and oiled) over the
paper cartridge
. Reassemble air cleaner, wing nut, cover and tighten
knob securely
CLEAN AIR INTAKE/COOLING AREAS
To insure proper cooling, make sure the grass screen,
cooling fins, and other external surfaces of the engine are
kept clean at al! times.
Every 100 hours of operation (more often under extremely
dusty, dirty conditions), remove the blower housing and
other cooling shrouds.. Clean the cooling fins and external
surfaces as necessary. Make sure the cooling shrouds are
reinstalled.
NOTE: Operating the engine with a blocked grass screen,
dirty or plugged cooling fins, and/or cooling shrouds re-
moved will cause engine damage due to overheating,
ENGINE OIL FILTER (See Fig. 17)
Reptace the engine oil filter every season or every other oit
change if the tractor is used more than 100 hours in one
year
• Drain oil from engine crankcase (See "TO CHANGE
ENGINE OIL" in this section of this manual, through
step remove drain plug)o
- Remove oil filter and wipe off filter adapter.
. Apply a thin coating of new engine oil to the rubber
gasket on replacement oil filter.
= Install replacement oil filter on filter adapter. ]'urn oil
filter c_ockwise until rubber gasket contacts the filter
adapter, then tighten filter an additional 1/2 turn,
o Filt crankcase with new oil (See 'q_'OCHANGE EN-
_31NEOIL" in this section of this manual). For approxi-
mate capacity see"PRODUCT SPECIFICATIONS" on
page 3 of this manual.
o Start the engine and check for oi! leaks. Correct any
leaks before placing engine into full operation,
2O
OIL FILTER
FIG. t7
MUFFLER
Inspect and replace corroded muffler and spark arrester (if
equipped) as itcould create a fire hazard and/or damage.
SPARK PLUGS
Replace spark plugs at the beginning of each mowing
season or after every 100 hours of use, whichever comes
first, Spark plug type and gap setting is shown in "PROD-
UCT SPECIFICATIONS" on page 3 of this manual.
IN-LINE FUEL FILTER (See Fig. 18)
The fuel filter should be replaced once each season_ if fuel
filter becomes clogged, obstructing fuel flow to carburetor,
replacement is required,
o With engine coot, remove filter and plug fuel line
sections.
o Place new fuel filter in position in fuel line with arrow
pointing towards carburetor
o Be sure there are no fuel line leaks and clamps are
properly positioned,
o Immediately wipe up any spilled gasoline,
CLAMP
FILTER
FIG. 18
CLEANING
o Clean engine, battery, seat, finish, etc. of all foreign
matter.
- Keep finished surfaces and wheels free of all gasoline,
oil, etc,
- Protect painted surfaces with automotive type wax.,
We do not recommend using a garden hose to clean your
tractor unless the electrical system, muffler, air fitter and
carburetor are covered to keep water out. Water in engine
can result in a shortened engine life.