Filter
Top Products
How to Stop Your Pressure Washer
1 Move throttle lever to "Stop" position
2. Squeeze trigger on spray gun to relieve
pressure in hose.
NOTE: A small amount of water will squirt out when
you release the pressure.
How To Use the Adjustable Nozzle
You now should know how to START your pressure
washer and how to STOP it. The information in this
section will tell you how to adjust the spray pattern
and apply detergent or other cleaning chemicals.
CAUTION
NEVER adjust spray pattern when spraying.
NEVER put hands in front of nozzleto adjust spray pattern.
On the end of your spray gun is a nozzle handle that
can adjust the spray pressure and the spray pattern.
1. Point nozzle toward ground, disengage safety
latch, and press trigger to test pattern.
2.
Sliding nozzle forward and back adjusts spray
pressure.
Slide nozzle backward for
high pressure mode,
3 Rotating nozzle adjusts spray pattern from a
narrow pattern to a fan pattern
Twist nozzle counter- Twist nozzle clockwise for
clockwise for fan pattern, narrow spray pattern,
4. For most effective cleaning, keep spray nozzle
between 8 to 24 inches away from cleaning
surface.
5. If you get spray nozzle too close, especially using
high pressure mode, you may damage the surface
being cleaned.
6. DO NOT get closer than 6 inches when cleaning
tires.
Using the Turbo Nozzle
The turbo nozzle rotates the high pressure stream in a
rapid circular pattern. The high pressure spray is most
effective when the tip of the nozzle extension is held
between 8 to 24 inches from the surface being
cleaned.
Always start the turbo nozzle at a distance, gradually
getting closer to the surface until you get the cleaning
force you want.
CAUTION
• Always make surethe surface you will clean will not be
damaged by the high pressure spray by testing in a
hidden area.
NOTE: Detergent cannot be applied with the turbo
nozzle.
Applying Detergent with Adjustable Nozzle
IMPORTANT: Use chemicals designed specifically for
pressure washers. Household detergents could
damage the pump.
CAUTION
• Starting the engine without all the hoses connected and
Slide nozzle forward for low without the water turned ON will damage the pump.
pressure mode and
detergent application,
9