Filter
Top Products
6. Pourslowly.Wipedipstickcleaneachtimeoil
levelischecked.DONOToverfill.
7. Installoilfill pluganddipstick,tightensecurely.
NOTE:Checkoiloftenduringenginebreak-in.
Add Fuel
,_ WARNING! NEVER fill fuel tank indoors
NEVER fill fuel tank when engine is running or
hot. DO NOT smoke when filling fuel tank.
_ WARNING! NEVER fill fuel tank completely
full. Provide space for fuel expansion. Wipe
away any fuel spillage from engine and
equipment before starting.
1. Use clean regular unleaded automotive fuel and
store in approved, clean, covered containers. Use
clean fill funnels. NEVER use "stale" fuel left over
from last season or fuel stored for long periods.
2. Clean area around fuel fill cap, remove cap.
3. Slowly add fuel to fuel tank. Use a funnel to
prevent spillage. Fill tank to about 1.5" below the
top of the filler neck.
Fuel
4. Install fuel cap and wipe up any spilled fuel
IMPORTANT: It is important to prevent gum deposits
from forming in essential fuel system parts, such as the
carburetor, fuel filter, fuel hose or tank during storage.
Also, experience indicates that alcohol-blended fuels
(called gasohol, ethanol or methanol) can attract
moisture, which leads to separation and formation of
acids during storage. Acidic gas can damage the fuel
system of an engine while in storage.
To avoid engine problems, the fuel system should be
emptied before storage of 30 days or longer. See
"Storage" on page 15. NEVER use engine or
carburetor cleaner products in the fuel tank or
permanent damage may occur.
Connect Hose and Water Supply to Pump
IMPORTANT: To avoid pump damage, you must
assemble the nozzle extension to the spray gun and
attach all hoses before you start the engine.
1. Uncoil high pressure hose and attach one end of
hose to base of spray gun. Tighten by hand.
2. Attach other end of high pressure hose to high
pressure outlet on pump. Tighten by hand.
,
Before connecting garden hose to water inlet,
inspect inlet screen. Clean screen if it contains
debris or have it replaced if damaged. Refer to
section "O-Ring Maintenance" if inlet screen is
damaged. DO NOT run pressure washer if inlet
screen is damaged. NEVER siphon inlet water.
"_._ Inspect inlet
screen. DO
NOT use if
damaged;
- clean if dirty.
4, Run water through garden hose for 30 seconds to
flush out any debris.
5, Connect garden hose (not to exceed 50 feet in
length) to water inlet. Tighten by hand.
CAUTION
• Damage to equipment resulting from failure to fellow
this instruction will void warranty,
6, Turn ON water and squeeze trigger on gun to
purge pump system of air and impurities.
WARNING
Always wear eye protection when using this equipment
or in vicinity of where equipment is in use,
Before starting the pressure washer, be sure you are
wearing adequate eye protection,
CHECKLIST BEFORE STARTING
ENGINE
Review the unit to ensure you have performed all of
the following:
1 Check that oil has been added to proper level in
engine crankcase
2 Add proper fuel to fuel tank.
3. Check for properly tightened hose connections
(high pressure and water supply) and there are no
kinks, cuts, or damage to high pressure hose
7