Filter
Top Products
Parts packed separately in carton (not shown full size)
2- Ignition Keys
(Attached to engine in plastic bag)
1-Snow Chute Assembly
IIIIIII I I •
_ ARNING: Always wearsatety glasses or eye shields
while assembling snow
thrower.
TOOLS REQUIRED FOR
ASSEMBLY
1- Knife to cut carton
1 - 1/2 inch wrenches
(or adjustable wrenches)
1 - 9/16 inch wrenches
(or adjustable wrenches)
1 - 3/4 inch wrenches
(or adjustable wrenches)
1 - Pliers (to spread cotter pin)
1 - Screwdriver
1 - Measuring tape or ruler
Figure 1 shows the snow thrower in the
shipping position.
Figure 2 shows the snow thrower com-
pletely assembled.
References to the right or left hand side
of the snow thrower are from the view-
point of the operator's position behind
the unit.
Auger Drive Lever
Traction
Drive Lever
Shifter
Lever
Clutch Cable
Crank Assembly
Chute
Deflector
F-001087J
Figure 1
7
Height
Adjust
Skid
Figure 2
TO REMOVE SNOW THROWER
FROM CARTON
1. Locate all parts packed separately
and remove from the carton.
NOTE: Place fuel stabilizer in a safe
place until needed for storage.