Filter
Top Products
REPAIR/ADJUSTMENTSSAFETY
• Afterstrikingaforeignobject,stopthe
engine (motor). Turn key to OFF position
and remove key to prevent accidental
starting. Thoroughly inspect the
snowthrower for any damage, and repair
the damage before restarting and
operating it.
• If snow thrower should start to vibrate
abnormally, stop engine (motor) and
check immediately for the cause.
Vibration is generally a warning of
trouble.
• Stop the engine (motor) whenever you
leave the operating position. Also, turn
key to OFF position and remove key
before unclogging the auger/impeller
housing or discharge chute, and when
making any repairs, adjustments, or
inspections. Remove wire from spark
plug to prevent accidental starting.
• When cleaning, repairing, or inspecting,
make certain the auger/impeller and all
moving parts have stopped.Turn key to
OFF position and remove key to prevent
accidental starting.
• Never attempt to make any adjustments
while the engine is running except when
specifically recommended by the
manufacturer.
• Maintain or replace safety and instruction
labels, as necessary.
• Run the snow thrower a few minutes after
throwing snow to prevent freeze-up of the
auger/impeller.
Z_ WARNING: This unit is equipped with
an internal combustion engine and should
not be used on or near any unimproved for-
est-covered, brush-covered or grass-cov-
ered land unless the engine's exhaust sys-
tem is equipped with a spark arrester meet-
ing applicable local or state laws (if any). If a
spark arrester is used, it should be main-
tained in effective working order by the op-
erator.
In the state of California the spark arrester is
required by law (Section 4442 of the Califor-
nia Public Resources Code). Other states
may have similar laws. Federal laws apply
on federal lands. A spark arresterimuffler is
available through your nearest Craftsman
Authorized Service Center (See ENGINE
REPAIR PARTS section in this manual).
Contents of Parts Bag
1 - 3.2 ounce container
Craftsman 2-cycle oil
1 - Owner's Manual (not shown)
1 -Warranty Card (not shown)
1 - Parts Bag (not shown)
1 - 10 ft. Electric Cord