Filter
Top Products
Assemble a shoulder bolt, a 3/8" lock washer and a
3/8" hex lock nut to the bottom hole in each side
plate. See figure 3.
Proceed to page 8.
J
FIGURE 3 RIGHT SIDE VIEW
• Attach the R.H. Side Plate (marked "R") to the right
side of the tractor frame as shown in figure 5. For the
front hole use a 3/8" x 1" hex bolt, a 3/8" lock washer,
and a 1/2" flat washer. Use the flat washer as a shim
between the frame and the side plate. For the rear
hole use a 3/8" x 1" hex bolt, and a 3/8" lock washer.
Repeat for the L.H. side.
NOTE: If the bolt inserts freely into the front hole, the
3/8" lock washer along with a 3/8" hex lock nut must
be assembled onto the bolt from inside the tractor
frame.
3/8" LOCK 1/2" FLAT
WASHER WASHER
[]
3/8" x 1"
HEX BOLT
R.H. SIDE
PLATE
TRACTORS WITH AXLE MOUNTED FRONT
SUSPENSION BRACKETS
• Remove any bolts present in the holes shown in
figure 4 on both sides of the tractor frame.
FIGURE 5 RIGHT SIDE VIEW
• Assemble a shoulder bolt, a 3/8" lock washer and a
3/8" hex lock nut to the bottom hole in each side
plate. See figure 6.
THESE HOLES
MUST BE EMPTY
\
\\ \ \\
FRONT
SUSPENSION
BRACKET
FIGURE 4 RIGHT SIDE VIEW
3_"HEX LOCK NUT
3/_ LOCK
W_SHER
3/8" SHOULDER BOLT
FIGURE 6 RIGHT SIDE VIEW
7