Filter
Top Products
ELECTRIC ATTACHMENT CLUTCHES
STEP 41: (SEE FtGURE 41)
* Attach the two suspension arms to the inside of the
clutch/idler assembly using two 5/16" x 3/4" hex bolts
(E)> 5/16" washers (U) and 5/16" nylock nuts COO)for
each arm. Place the washers between the arms and
the assembly frame
5/16" NYLOCK 5/16" x 314"
NUT (CC) 5/16" WASHER (U) HEX BOLT (E)
FIGURE 41
STEP 42: (SEE FIGURE 42)
* Pace the extra tensioning chain (PP) through the left
front hole in the cluteh4dler assembly and then turn
the assembly upside down
STEP 43: (SEE FIGURE 43)
Hook the spring from the parts bag through the end of
the tensioning chain
Hook the other end of the spring onto the bottom of
the bolt and nut which secure the idler pulley to the
upper idler arm. Hold the bolt head and assemble a
3/8" hex lock nut (DD) onto the bolt, leaving enough
space for the spring to pivot freely between the two
nuts.
Attach a 3/32" hairpin cotter (LL) to the chain, placing
it in the fifth link from the spring•
ATTACH
SPRING
HERE
SPRING 5TH LINK
CHAIN
(LH. SIDE)
3/32" HAIR
COTTER PIN (LL)
RIGHT LEFT
SIDE SIDE
FIGURE 43 VIEW OF BOTTOM
_- _ / LEFT FRONT HOLE
TENSIONING CHAIN (PP)
FIGURE 42
STEP 44: (SEE TABLE 2)
Two different length drive belts are included with
your snow thrower• Use the table below to select
the correct drive belt for your type tractor The part
number is printed on the outside of the belt
Set aside the belt that is not for your tractor to avoid
accidentally using it
55" CELT (PART #46989)
TRACTOR TYPE DECK SiZE j_ CLUTCH TYPE
(LT) Lawn Tractor 38", 42", 46" _ Electric
56" BELT (PART #48188)
TRACTOR TYPE DECK SIZE _ CLUTCH TYPE
(LT) Lawn Tractor 48" Electric
TABLE 2
19