Craftsman 486.24838 Snow Blower User Manual


 
iNSTRUCTiONS FORTRACTORSWITH DUAL STEP 23: (SEE FIGURE 22)
FRONT DECK SUSPENSION BRACKETS Remove any bolts found in the holes shown.
FASTEN SIDE PLATES TO TRACTOR
If your tractor resembles figure 20, go to step 21.
If your tractor resembles figure 22 go to step 23
STEP 21: (SEE FIGURE 20)
Remove bolts from front three holes shown
If a bolt is present in the fourth hole, replace it with a
5/16" x 1" cardage bolt (N) without a nut The bracket
fastened to inside of frame must remain in place
REPLACE HOLT
(IF PRESENT)
REMOVE BOLTS
(IF PRESENT)
FIGURE 20
\ /,
k
FRONT
SUSPENSION
BRACKET
RIGHT SiDE ViEW
STEP 22: (SEE FIGURE 21)
Fasten the RH Side Plate (bend facing out) to the
front three holes shown in the tractor frame using
three 3/8" x 1" thread forming bolts (G), three 3/8"
lock washers (S) and one 1/2" washer (V) placed on
the thffd bolt as a shim between the side plate and
the frame.Tighten all bolts Repeat for the L.H side.
NOTE: If you installed a bolt in the fourth hole in step 21,
assemble a 5/16" flange nut (AA) onto the bolt after the
side plate is installed.
Go to step 28 oH this page.
5/16" x 1"
CARRIAGE BOLT(N)
(SEE NOTE)
1/2" WASHER (V)
5/16" FLANGED
NUT (AA)
(SEE NOTE)
\
(3) 318" x 1"
I THREAD FORMING (3) 3/8" LOCK
/ BOLTS (G) WASHERS (S)
REMOVE BOLTS
IF PRESENT
\
\
\ _ k\
SUSPENSION
/, i
/ i BRACKET
FIGURE 22 RIGHT SIDE VIEW
STEP 24: (SEE FIGURE 23)
Fasten the RH Side Plate (bend f_cing out) to the
three holes shown in the tractor h_me Use three 3/8"
x 1" thread forming bolts (G) and 3/8" lock washers (S).
Tighten all bolts and repeat for the L.H. side
NOTE: If the bolt inserts heely into the front hole, assemble
a 3/8" flanged nut (BB) onto the bolt
(3) 3/8" LOCK
/ _, WASHERS(S)
(3)3/8"×1" i
THREAD FORMING / 3/8" FLANGED NUT (BB)
/ (SEE NOTE)
BOLTS (G)
FIGURE 23 RIGHT SIDE ViEW
STEP 28: (SEE FIGURE 24)
Assemble a shouEder bolt (P) and a 3/8" washer (X)
to the outside of each side plate, securing them with
a 3/8" flanged nut (BB)
J
\
\
\
SHOULDER
BOLT (P)
3/8" WASHER (X)
/
/
3/8" FLANGED
NUT(BB)
RIGHT SIDE VIEWFIGURE 21 RIGHT SiDE VIEW FIGURE 24
13