Filter
Top Products
STEP 4: (SEE F_GURE3}
, Attach left mounting bracket to hole shown in left side
of tractor frame using bolt (C), !ock washer (H) and
flat washer (I). Align middle hole in bracket with empty
hole in tractor frame and tighten bolt (C) to hold
bracket in place. Repeat for right mounting bracket.
(GT) FRAME SHOWN
LEFT MOUNTING FLAT
BRACKET WASHER BOLT
(0 (c}
ATTACH TO
LOCK
THRSHOLE
WASHER
(H}
BUMPER STOPS
FACE OUT
FIGURE 3
/
ALIGN THESE HOLES
LEFT SiDE VIEW
STEP 5: (SEE FIGURE 4)
, Place plug (D) on a work bench or solid table and
push end of bumper down onto ptug. Repeat for al!
four plugs.
BUMPER
PUSH DOWN
WUTH EVEN
PRESSURE
WORK BENCH
OR SOLID TABLE __ PLUG (B)
\
FIGURE 4
STEP 6: (SEE FIGURES 5 AND 6}
, Assemble plastic grips (F) onto locking levers.
, To attach bumper to tractor:
1. Place flattened ends of bumper onto mounting
brackets. Insert pin of locking lever through front
hole in bumper and into front hole in mounting
bracket to support bumper on mounting bracket.
2. insert pivot spacers (E) into rear holes in bumper.
PUVOT
SPACER
(E)_
LOCKING LEVER
J
FIGURE 5
/
GRUP (F)
I
LEFT SIDE VIEW
,
Fasten locking lever and bumper to mounting bracket
using a screw (A) or bolt (B), a lock washer (H) and a
flat washer (I). Use screw (A) for LTtractors and bolt
(B) for GT tractors. Assemble screw or bolt through
pivot spacer in rear hole in bumper and into tractor
frame. Tighten. Repeat for other side.
NOTE: If hole in (LT) tractor frame is not threaded, push
in while turning screw (A) to create threads in hole.
IMPORTANT: You must lower bumper before raising tractor
hood. Pu!! out on locking levers and push bumper down as
far as it will go.
FLAT I
WASHER d)
FIGURE 6
/
LEFT S_DE VIEW