Filter
Top Products
STEP 3: (SEE FIGURE 4)
, Attach left mounting bracket to hole shown in left side
of tractor frame using a hex bolt (C), fiat washer (I)
and nylock nut (G). Align middle hote in bracket with
empty hole in tractor frame. Tighten nylock nut (G)
only enough to keep bracket in alignment until step 4.
Repeat for right mounting bracket.
(GT) FRAME SHOWN
HEX LEFT MOUNTING
BUMPER STOPS BOLT (C) BRACKET
FACE OUT _ NYLOCK
NUT (G)
FIGURE 4
FLAT
WASHER (0
/
AUGN THESE HOLES
LEFT SIDE VIEW
STEP 5: (SEE FIGURE 6)
, Replace the front screws and browning shield you
removed in Step 1 as shown.
FRONT SCREWS
REPLACE
BROWNmNG SHmELD
FIGURE 6 LEFT SIDE VIEW
STEP 4: (SEE FIGURE 5)
, Fasten bumper to mounting bracket using a hex bolt
(B), pivot spacer (E), a locking lever, a fiat washer
(I) and a ny!ock nut (G) as shown, The pivot spacer
inserts into hole in bumper. Tighten both nuts on
mounting bracket at this time. Repeat for other side.
, Assemble plastic grips (F) onto locking levers.
, Lift up on bumper until pins in locking levers snap into
holes in mounting brackets.
IMPORTANT: You must lower bumper before raising tractor
hood. Pu!! out on locking levers and push bumper down as
far as it will go.
PIVOT
SPACER (E)_
FIGURE 5
FLAT
WASHER (I)
GRUP (F)
LEFT SIDE VIEW