Filter
Top Products
Assemble the bose adaptor (nozzle) to the front of
the impeller housing, securing it with the three knobs.
Make sure that the switch actuator bracket depresses
the switch on the housing. See figure 24.
HOSE ADAPTER
(NOZZLE)
KNOB 1
FIGURE 24
SW_CH
ACTUATOR SAFETY
BRACKET SW_CH_
• Place a hose c_amp onto the end of the hose. Push
the hose onto the hose adapter (nozzle). Tighten the
hose clamp onto the hose and hose adapter. Do not
collapse the hose adapter when tightening the
clamp. See figure 25,
• The remaining hose clamp will be used later to fasten
the hose to the deck adapter.
• Place the hose hanger rod assembly down into the
hose hanger bracket on the impeller housing assem-
bly. See figure 26.
• Loop the rubber tie strap under the hose. Fasten the
hooks to the hose hanger rod assembly. See figure
26.
HOSE HANGER
ROD ASSEMBLY
25"TARP
STRAP
FIGURE 26
HINT: Tip the cart bed back for easier access in the
next paragraph.
• Attach the chipper chute assembly to the weld bolts
on the back side of the impeller housing using three
5/16" flat washers and 5/16" Nylock nuts. Tighten.
See figure 27. -
• insert the tamper plug into the end of the chipper
chute assembly.
HOSE ADAPTER
(NOZZLE)
CLAMP
CHIPPER CHUTE
ASSEMBLY
_16"
NYLOCK _16" FLAT
NUT WASHER
FIGURE 27
FIGURE 25
15