Craftsman 486.243223 Spreader User Manual


 
6
OPERATION
HOW TO USE YOUR SPREADER
ADJUSTING THE FLOW RATE SETTING
Loosen the wing nut that fastens the control to the
handle.
Slide the Adjustable stop to the desired setting and
retighten the wing nut. See gure 9.
KNOW YOUR SPREADER
Read this owner's manual and safety rules before
operating your Spreader.
Compare the illustration below with your Spreader to
familiarize yourself with the various controls and their
locations.
FLOW CONTROL LEVER Opens and closes the ow
plate on the bottom of the hopper.
ADJUSTABLE STOP Allows the ow control lever to be
moved to the same setting repeatedly.
APPLICATION TIPS
This unit will cover a 4 to 8 foot wide area depending
on the material used and the towing speed.
To avoid misses or striping, make each pass about
5 feet from the previous one so some overlapping of
spread pattern does occur.
For easiest application, spread across the shortest
edges of lawn rst, making two "header" strips for a
turning area, and then spreading between the header
strips. See gure 10.
If lawn is odd shaped, spread a border around the
edges and then spread between the border. See
gure 10.
Keep wheel approximately 4 feet from any area you
do not wish to spread.
IMPORTANT: Be careful when using spreader around
ornamental plants because weed control chemicals can
damage these plants.
USING YOUR SPREADER
Check the material package and the Spreader
Settings sheet included with your spreader for the
proper spreader setting and application rate.
Before lling spreader, move the control lever to the
"OFF" position.
Move spreader onto a at surface - either a walk or a
driveway - and ll.
Slide the Adjustable Stop to the desired setting.
Start the spreader in motion, then move the control
lever forward against the adjustable stop to begin
spreading.
NOTE: Always place control lever in the "OFF" position
while lling spreader and when stopping or turning, to
prevent release of excess fertilizer.
FIGURE 10
FLOW CONTROL LEVER
ADJUSTABLE STOP
FIGURE 9
DO NOT EXCEED 6 MPH WHILE TOWING
SPREADER