Filter
Top Products
5
B
D
F
F
F
C
D
D
FIGURE 5
FIGURE 6
FIGURE 7
• Attach the (RH) and (LH) hitch tubes to the frame tube
using four 1/4" x 2" hexbolts (C) and 1/4" nylock nuts
(D). Tighten. See gure 6.
• Assemble the Control Cable to the Hitch Control Tube
using the carriage bolt and nylon wing nut. Tighten.
See gure 7.
• Assemble the (RH) and (LH) hitch tubes to the control
tube using two 1/4" x 1-3/4" hex bolts (B) and 1/4"
nylock nuts (D). Tighten. See gure 5.
• Assemble the plastic caps onto the ends of the hitch
tubes and control tube as shown in gure 5.
FIGURE 8
B
D
H
E
• Assemble the Hitch Brackets to the Hitch Control Tube
using two 1/4" x 1-3/4" hex bolts (B) and 1/4" nuts (D).
Tighten. See gure 8.
• Assemble the hitch pin (H) through the hitch brackets
and secure with the 1/8" hair cotter pin (E). See gure
8.