Craftsman 486.24229 Lawn Sweeper User Manual


  Open as PDF
of 16
 
8
Call 1-866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE
STEP 13: (SEE FIGURE 13)
Secure the top and bottom hopper tubes together 1.
using two 5/16" x 3/4" hex bolts (17) on inside and
two 5/16" nylock nuts (21) outside.
STEP 14: (SEE FIGURE 14)
Install two cotter pins (27) in the rear hopper tube. •
Bend ends of cotter pins around tube.
Slide the dump handle clip (33) onto the dump handle.•
Attach the dump tube to the rear hopper tube using a •
U-clamp (34) placed between the cotter pins, a 1/4" x
1-1/2" hex bolt (16) and a 1/4" nylock nut (24).
Swivel the dump tube so that the end of the tube •
rests on the ground behind the bag and supports the
rear of the bag in an upright position.
STEP 15: (SEE FIGURE 15)
Insert the hopper support rods (7) into the hole •
beneath the curved head bolt (26) in each upper
hopper tube. Flex and insert the rod into the hole in
the bottom rear hopper tubes as shown.
NOTE: Thehoppersupportrodswillexaboutasmuch
asshowningure15whentheyareassembled.
STEP 16: (SEE FIGURE 16)
Slidethepivotrod(2)throughtheapinthebag's•
windscreenrstandthenthroughtheholeineach
upper hopper tube.
Hammer a palnut (23) onto each end of the pivot rod . •
HINT: Place the bag on its side on a hard surface to
make installation of palnuts easier.
FIGURE 13
17
17
21
21
FIGURE 14
24
27
16
34
5
33
FIGURE 15
7
7
26
7
FIGURE 16
2
23
 previous next