Filter
Top Products
7
ASSEMBLY OF HOPPER BAG
STEP 10 - ASSEMBLE UPPER TUBES
•
Fit the ends of the two upper hopper tubes into the
ends of a rear hopper tube. Align the holes in the ends
of the tubes and insert plastic plugs (Q). See fi gure 7.
NOTE:
Either side of the tubes can face up.
FIGURE 7
FIGURE 9
UPPER
HOPPER
TUBE
HOPPER
BAG
BOTTOM
STITCHED SLEEVE
STEP 11 - ASSEMBLE LOWER TUBES
•
Fit the ends of the two lower hopper tubes into the
ends of a rear hopper tube. Align the holes in the ends
of the tubes and insert plastic plugs (Q). See fi gure 8.
NOTE:
Either side of the rear hopper tube can face up.
FIGURE 8
FIGURE 10
LOWER HOPPER TUBE
HOPPER BAG
BOTTOM
UPPER HOPPER
TUBE
CLEVIS PIN (M)
HAIR COTTER
PIN (L)
UPPER
HOPPER
TUBE
PLASTIC PLUG (Q)
REAR
HOPPER
TUBE
LOWER
HOPPER
TUBE
PLASTIC PLUG (Q)
REAR
HOPPER
TUBE
STEP 12 - ASSEMBLE TUBES TO BAG
•
Unfold the hopper bag, reverse the fold of the mesh
wind screen and then lay the bag out fl at with the wind
screen on top and the Craftsman logo facing down.
•
Insert the ends of the assembled upper hopper tubes
down through the stitched sleeves in the sides of the
hopper bag and then slide the tubes back underneath
the wind screen. See fi gure 9.
•
Place the assembled lower hopper tubes in
to the
bottom of the hopper bag and then slide the tubes to
the back of the
bag. See fi gure 10
.
•
Attach the ends of the lower hopper tubes to the
inside
of the upper hopper tubes using two clevis pins
(M) inserted from the inside, and two hair cotter pins
(L). See fi gure 10.