Filter
Top Products
6
FIGURE 6
FIGURE 5
STEP 9 - ATTACH KNOB
•
Place the tooth-lock washer (H) between the height
adjustment handle and the height adjustment strap.
Insert the carriage bolt (D) through the handle, the
tooth-lock washer and the strap. Assemble the fl at
washer (G) and the plastic knob (S) onto the end of
the bolt and tighten. See fi gure 6.
STEP 7 - TIGHTEN BOLTS
•
At this time
tighten
the four bolts in fi gure 1 that
fasten the hitch tubes to the sweeper housing. Next,
tighten
the two bolts in fi gure 2 that fasten the ends
of the hitch tubes together. Finally,
tighten
the two
bolts in fi gure 3 or 4 that fasten the hitch brackets to
the hitch tubes.
STEP 8 - ATTACH HANDLE
•
Assemble the height adjustment handle to the height
adjustment tube on the front of the sweeper housing.
Use the curved head bolts, bowed washers, lock
washers and hex nuts which come pre-assembled to
the tube. Position the height adjustment handle side to
side so that the height adjustment strap will align up
against the outside of the handle and then
tighten
the
nuts. See fi gure 5.
•
Assemble the grip (R) onto the end of the height
adjustment handle as shown in fi gure 5.
CURVED
HEAD BOLT
BOWED
WASHER
LOCK
WASHER
HEX NUT
GRIP (R)
HEIGHT
ADJUSTMENT
HANDLE
HEIGHT
ADJUSTMENT
TUBE
HEIGHT
ADJUSTMENT
STRAP
CARRIAGE BOLT (D)
TOOTH LOCK
WASHER (H)
KNOB (S)
FLAT WASHER (G)
HEIGHT
ADJUSTMENT
HANDLE
HEIGHT
ADJUSTMENT
STRAP