Filter
Top Products
ii i iin nl iiiiiiiiiiiiinnmmllln
HARDWARE CONTENTS
PARTS PACKED SEPARATELY IN CARTON NOT SHOWN ACTUAL SIZE
Operator's Manual
Blower Tube
Upper Vacuum Tube
Concentrator Nozzle
Lower Vacuum Tube
Collection Bag
i rl iiill ml i i i iii
ASSEMBLY
iiiii i 111111111111 ii i iiii iii
REMOVE BLOWER FROM CARTON
• Remove leose parts included with Blewer/vac.
• Remove all packing material.
• Check cartonthoroughly foradditionalloose parts+
ASSEMBLE YOUR UNIT INTO A
BLOWER OR VACUUM MODE
You can assemble your unit as a blower or a vacuum. Later
you can refer to these instructionsand reconfigure your unit
into a different mode. The instructions below provide
information on how to assemble your unit for both
configurations.
HOW TO ASSEMBLE YOUR UNIT AS A
BLOWER (Fig. 1 )
BLOWER
Figure 1
Ifyour unitisconfigured inthevacuummode, turn the unitoff
and disconnect it from the power source. Remove the
vacuum tubes and collection bag. Be sure to latch the inlet
cover closed.
ATTACHING THE BLOWER TUBE & NOZZLE
(Fig. 2 & 3 )
Remove the vacuum tubes and collection bag, ifassembled
to the unit.
• Insert the blower tube into the blower outlet.
• Turn the blower tube clockwise until it isfirmly seated in
the blower outlet,
• With a slight twisting motion, slide nozzle firmly into the
end of the blower tube.
Blower Outlet
"=" Blower Tube
Figure 2
Blower Tube ,,__
Concentrator Nozzle
Figure 3
-5-