Filter
Top Products
I I IIIII IIIIII
QUICK REFERENCE PAGE
Read and follow all Safety Rules, Precautions and Operating Instructions.
Failure to do so can cause in serious personal injury.
PAGE
PREPARATION ........................................................................... 3
1. Know all safety rules and precautions inthis manual.
2. Wear safety glassesor goggles for eye protection
3. Dress safely - bootsor safetyshoes, long pants.
4. Check for worn, loose, missing or damaged parts and repair.
5. Inspect and ensure the area to be cut issafe.
6. Keep children, bystanders,and animals a minimum of 30 feet (10 meters)away from thework area.
FUELING ............................................................................... 6-7
1. Eliminate all sourcesofsparks orflame where fuel ismixed, pouredor stored.
2. Use fuel notover2 months old.
3. Mix and pour fuel inan approved, marked container in an outdoorarea.
4. Use 1 partair-cooled, 2-cycle,engine oilto 16parts regular unleaded gasoline.
5. Move a minimum of 10feet (3 meters)away from fuel and fueling site before startingengine.
STARTING THE ENGINE ................................................................ 7- 8
1. Extend a minimum of4 inches of line from the cutting head.
2. Place unit on groundaway from objects and on-lookers.
3. Keep the throttletrigger depressed untilengine runs.
4. Press injectorbuttonas indicated on page 8.
5. Pull the starter rope sharply and quickly.
OPERATING THE UNIT ....... .......................................................... 9- 11
1. Acceleratethe engine to the desired speed before cutting.
2. Release the trigger and allowtheengine toidle when notcutting.
& Make sure the cuttinghead stopstuming when the throttletrigger is released.
4. Stopthe engine by moving the ignitionswitchto the "off" position,
ADVANCING THE CUTTING LINE ......................................................... 10
1. Operate the engine at full throttle.
2. Hold cutting head parallel to grassyarea of ground.
3. Tapcutting head lightlyon the ground once.
MAINTENANCE .......................................................................... 14
1. Drain all fuel fromthe unitbefore storingfor more than 30 days.
2. Disconnect spark plug before performingany maintenance exceptfor carburetor adjustment.
3. Clean air filter frequently butalways after 5 hours of operationor 5 tanks of gas whichever isless.
4. Lubricatethe flexibledrive shaft after each 10 hoursofoperationand afterstoringformore than 90 days.
5. Store ina dry place outof the reach of children.
I]11 II II]] I]1 I]]111 II
27