Filter
Top Products
h.
Pull on the nylon line to change the spool from the
lockedposition to the operating position. Figure 24.
Obtain correct line length bypressing tap button and
pulling on nylon line again.
NOTE: Approximately 2 inches of line can be
advanced each time the tap button is pressed.
Figure 24.
USE ONLY SEARS/CRAFTSMAN ®
REPLACEMENT PARTS
2. CUTTING LINE REPAIR
• If the cutting line breaks off or backs up in the
cutting head, follow "Cutting Line Replacement",
omittingstep "e".
3. SPOOL REPLACEMENT
a Replace the spool when: The square corners of
the drive lugs are rounded off, reduced in size, or
broken off. Figure 25.
b. To replace the spool, follow "Cutting Line
Replacement" (page 12).
4. LINE LIMITER MAINTENANCE
• The line limiter isthe metal blade found on the
splash deflector.
_-Theline-limiter must be kept sharp to:
-- allow fast, easy cut-off.
avoid excessive wear to the cutting head.
•• To sharpen:
Use a fiat file and file from the outside towardthe
insideof the line limiter,Figure 26.
in
Approximately2 inches
of line canbeadvanced
eachtime the Tap Button
is pressed.
TAP BUTTON
Figure 24
NORMAL SPOOL
i ii
Figure 25
WORN SPOOL
Figure 26
NOTES
13