Filter
Top Products
3.Pushtheattachmentintothecou-
pleruntilthelocking/releasebutton
snapsintotheprimaryhole.
4.Beforeusingtheunit,tightenthe
knobsecurelybyturningclockwise.
coupler PrimaryHole
GuideRecess
Upper Locking/ Attachment
Shaft Release
Button
_WARNING: Make sure the lock-
ing/release button is locked in the pri-
mary hole and the knob is securely
tightened before operating the unit.
Using the wrong hole could lead to
serious injury or damage to the unit.
Secondary Hole
Locking/Release
Button in Primary Hole
INSTALLING ATTACHMENT
HANGER
An attachment hanger is provided for
storage when attachment is not in
use,
To install hanger on attachment:
1= Remove the shaft cap from the at-
tachment (if present) and discard.
2= Press and hold the locking/release
button.
3= Push hanger onto the attachment
until the locking/release button
snaps into the hole.
OPERATING POSITION
ALWAYSWE_:_. _Eye
Protection
Long Pad_i)i_i)nts_
Heavy Sho_ 1 _,
When operating unit, stand as shown
and check for the following:
• Wear eye protection and heavy
clothing.
• Keep right arm slightly bent with
right hand holding the trigger handle
of powerhead.
• Keep left arm extended with left
hand holding the handlebar.
• Keep unit below waist level.
• Adjust edger wheel for proper cut
depth.
_;;_,WARNING: Never attempt to
adjust the edger wheel when the unit
is in operation. Always stop the pow-
erhead, wait until the blade stops turn-
ing, and disconnect the spark plug (or
disconnect powerhead from power
source) before making adjustments.
EDGING
As you become familiar with use of
your edger attachment, you will be
able to determine your own operating
pace. Conditions such as depth of cut
and material being cut will regulate the
speed and time required for your edg-
ing job.
• Allow the engine to warm up before
you begin edging.
• Increase the engine speed before
placing the blade in the cut. For best
results, run the engine at full throttle
while cutting.
• Always work going away from people
and solid objects such as walls, large
stones, trees, automobiles, etc.
• Be careful when edging near trees or
valuable plants. The high speed metal
blade may cut roots and cause dam-
age to the plants.
• Ifthe blade stalls, immediately move
the unit back slightly to allow the
blade to restart. Ifthe blade continues
to stall, stop the engine, disconnect
the spark plug, and inspect for block-
age or damage.
,_,WARNING: Keep the blade area
clean. Always release the throttle trig-
ger, move the powerhead ON/OFF
switch to the OFF position, disconnect
the spark plug (or disconnect power-
head from power source), and make
sure the blade has completely
stopped turning before cleaning.