Filter
Top Products
• Dressproperly.Alwayswearsafety
glassesorsimilareyeprotectionwhen
operating,orperformingmaintenance
onyourunit(safetyglassesareavail-
able).Eyeprotectionshouldbe
markedZ87.
• Alwayswearfaceordustmaskifop-
erationisdusty.
• AlwayswearheaW,longpants,long
sleeves,boots,andgloves.
• Alwayswearfootprotection.Donot
gobarefootorwearsandals.
• Securehairaboveshoulderlength.
Secureorremovelooseclothingor
clothingwithlooselyhangingties,
straps,tassels,etc.Theycanbe
caughtinmovingparts.
• Beingfullycoveredalsohelpsprotect
youfromdebrisandpiecesoftoxic
plantsthrownbyspinningblade.
• Stayalert.Donotoperatewhenyou
aretired,ill,upset,orundertheinflu-
enceofalcohol,drugs,ormedication.
Watchwhatyouaredoing;usecom-
monsense.
• Wearhearingprotection.
• Neverstartorruninsideaclosed
roomorbuilding.Breathingexhaust
fumescankill.
• Keephandlesfreeofoilandfuel.
• Onlyoperateunitwithhandlebar
installed.
• Keephandsandfeetawayfromcut-
tingarea.
• Neverdirectdischargeofmaterialto-
wardbystandersnorallowanyone
neartheareaofoperation.Usecare
indirectingdischargetoavoidglass
enclosures,automobiles,andthelike.
FUEL SAFETY (for gas powerheads)
• Mix and pour fuel outdoors.
• Keep away from sparks or flames.
• Use a container approved for fuel.
• Do not smoke or allow smoking near
fuel or the powerhead.
• Avoid spilling fuel or oil. Wipe up all
fuel spills before starting the power-
head.
• Move at least 10 feet (3 meters) away
from fueling site before starting power-
head engine.
• Stop engine and allow to cool before
removing fuel cap.
• Remove fuel cap slowly.
ELECTRICAL SAFETY (for electric
powerheads)
,4I_WARNING: Avoid a dangerous
environment. To reduce the risk of
electrical shock, do not use in rain, in
damp or wet locations, or around
swimming pools, hot tubs, etc. Do not
expose to snow, rain, or water to avoid
the possibility of electrical shock. Do
not handle extension cord plug or unit
with wet hands.
• Use only a voltage supply as shown
on the nameplate of the unit.
• Avoid dangerous situations. Do not
use in presence of flammable liquids
or gases to avoid creating a fire or
explosion and/or causing damage to
unit.
• Avoid dangerous environments. Do
not use in unventilated areas or
where dust or explosive vapors can
build up.
• To reduce the risk of electrical shock,
use extension cords specifically
marked as suitable for outdoor ap-
pliances. The electrical rating of the
cord must not be less than the rating
of the unit. The cord must be marked
with the suffix WV-A" (in Canada, "W").
Make sure your extension cord is in
good condition. Inspect extension
cord before use and replace if dam-
aged. An undersized extension cord
will cause a drop in line voltage result-
ing in loss of power and overheating.
If in doubt, use the next heavier
gauge. The smaller the gauge num-
ber, the heavier the cord.
• Do not use multiple cords.
• The powerhead may have a polarized
plug (one blade is wider than the oth-
er); if so, it will require the use of a po-
larized extension cord. The appliance
plug will fit into a polarized extension
cord only one way. If the plug does
not fit fully into the extension cord, re-
verse the plug. If the plug still does
not fit, obtain a correct polarized ex-
tension cord. A polarized extension
cord will require the use of a polarized
wall outlet. This plug will fit into the po-
larized wall outlet only one way. If plug
does not fit fully into the wall outlet,
reverse the plug. If it still does not fit,
contact a qualified electrician to install
the proper wall outlet. Do not change
the equipment plug, extension cord
receptacle, or extension cord plug in
any way.
• Do not attempt to repair unit. Inspect
the insulation and connectors on the
powerhead and extension cord before
each use. If there is any damage, do
not use until damage is repaired by
your Sears Service Center.
• Do not pull or carry by cord; do not
use cord as a handle, close a door on