Filter
Top Products
increase the chance of kickback, Fol-
low manufacturer's chain sharpening
and maintenance instructions. Check
tension at regular intervals, but never
with engine running. Make sure bar
clamp nuts are securely tightened.
• Begin and continue cutting at full
speed, if the chain is moving at a
slower speed, there is greater chance
of kickback occurring.
• Use extreme caution when reentering
cut.
• Do not attempt cuts starting with the
tip of the bar (plunge cuts).
• Watch for shifting logs or other forces
that could close a cut and pinch or fall
into chain.
• Use the specified Reduced-Kickback
Guide Bar and Low-Kickback Chain.
Avoid Pinch-Kickback:
• Be extremely aware of situations or
obstructions that can cause material
to pinch the top of or otherwise stop
the chain.
• Do not cut more than one log at a
time.
• Do not twist saw as bar is withdrawn
from an undercut when bucking.
Avoid Pull-In:
• Always begin cutting with the engine
at full speed and the saw housing
against wood.
• Use wedges made of plastic or wood.
Never use metal to hold the cut open.
MAINTAIN CONTROL
Standto theleftofthe saw
Thumbon =
underside
of handlebar
Elbow
locked
Neverreversehand positions
• A good firm grip on the saw with both
hands will help you mainta n control.
Don't let go. Grip the rear handle with
your right hand whether you are right
or left handed. Wrap the fingers of
your left hand over and around the
front handlebar, and your left thumb
under the front handlebar. Keep your
. left arm straight with the elbow locked.
Position your left hand on the front
keep _our body from being in a direct
line with the cutting chain.
• Stand with your weight evenly bal-
anced on both feet.
• Do not overreach. You could be drawn
or thrown off balance and lose control.
• Do not cut above shoulder height, tt is
difficult to maintain control of saw
above shoulder height,
KICKBACK SAFETY FEATURES
WARNING: The following features are
included on your saw to help reduce
hazard of kickback; however, such fea-
tures will not totally eliminate this dan-
get. Do not rely only on safety devices.
• Handguard: designed to reduce the
chance ofyour left hand contacting
the chain ifyour hand slips off the
front handlebar.
• Position offront and rear handlebars:
designed with distance between han-
dles and "in-line" with each other. The
spread and "in-line" position of the
hands provided by this design work
together to give balance and resls-
tance in controlling the pivot of the
saw back toward the operator ifkick-
back occurs.
- Reduced-Kickback Guide Bar: de-
signed with a small radius tip which
reduces the size of the kickback dan-
ger zone. This type bar has been
demonstrated to significantly reduce
the number and seriousness of kick-
backs when tested in accordance with
ANSI B175.1.
LargeRadius [i
"tipGuide Bar
SmatlRadius
Tip GuideBar
• Low-Kickback Chain: has met kickback
performance requirements when tested
on a representative sample of chain
saws below 3,8 cubic inch
displacement specified in ANSi B175.1.
Low-I_ckback Chain
Contoured Depth Gauge
_ longated Guard Link
Deflects Kickback
Force And Allows
Wood To Gradually
Ride Into Cutter
SAFETY NOTICE: Exposure to
handlebar soit isin a straight line with vibrationsthroughprolonged use of
your right hand on the rear handle gasoline powered hand tools could,
when making bucking cuts. Stand cause blood vessel or nerve damage in
slightlyto the left side of the saw to the fingers, hands, and joints of people
4