Filter
Top Products
11
ASSEMBLY
If adjusting the auger cable, thread the lock nut down the coupler 4.
towards the end of the thread to lengthen the cable as necessary
to stop the auger from turning when the control is released.
Reattach the spring to the 5. rearmost hole in the actuator bracket.
Repeat the wheel drive and auger control tests to verify proper 6.
adjustment. Repeat previous steps if necessary to attain proper
adjustment of each cable.
Testing Auger Drive Control
When the auger control is released and in the disengaged “up” posi-
tion, the cable should have very little slack, but should NOT be tight.
Refer to Fig. 9 for location of controls.
In a well-ventilated area, start the snow thrower engine as 1.
instructed in the Operation section.
While standing in the operator’s position (behind the snow 2.
thrower), engage the auger control and allow the auger to remain
engaged for approximately ten seconds before releasing the
auger control. Repeat this several times.
With the engine running and the auger control in the disengaged 3.
“up” position, walk to the front of the machine. Confirm that the
auger has completely stopped rotating and shows no signs of
motion.
If the auger shows any signs of rotating, immediately return to the 4.
operator’s position and shut off the engine. Wait for all moving
parts to stop before readjusting the auger control cable.
Testing Wheel Drive Control & Speed Selector
Shift Lever
Refer to Fig. 9 for location of controls.
Move the shift lever into sixth (6) position.1.
With the wheel drive control released, push the snow thrower 2.
forward, then pull it back. The machine should move freely.
Engage the drive control and attempt to move the machine both 3.
forward and back, resistance should be felt.
Move the shift lever into the fast reverse (R2) position and repeat 4.
the previous two steps.
If you experienced resistance rolling the unit, either when repositioning
the shift lever from 6 to R2 or when attempting to move the machine
with the drive control released, adjust the drive control immediately.
See Adjusting Drive and Auger Controls.
Adjusting Wheel Drive & Auger Controls
From beneath the handle, pull downward on the appropriate cable 1.
and unhook the spring found on the end of the cable from its
respective actuator bracket. Refer to Fig. 9 and 10.
Slide the spring up the cable to expose the cable coupler threads 2.
and lock nut. Refer to Fig. 11.
If adjusting the drive cable, thread the lock nut outward (down the 3.
coupler towards the end fo the thread) to lengthen the cable and
allow the unit to move freely when the control is released. Thread
the lock nut inward (up the coupler towards the cable) to shorten
the cable to reduce slippage and prevent the machine from being
easily moved with the drive control engaged.
Figure 10
WARNING
Prior to operating your snow thrower, carefully read and follow all
instructions below. Perform all adjustments to verify your snow
thrower is operating safely and properly.
Figure 11
WARNING
Do not over-tighten the cable. Over-tightening may prevent the auger
from disengaging and compromise the safety of the snow thrower.