Filter
Top Products
TOOL KIT
Your unit is provided with a tool kit (Fig.l). This tool kit
consists of the following:
4 mm Allen Wrench
5 mm Allen Wrench
_¢// 8 & 10 mm Wrench
_ Four 5 mm Screws
(/_ with captive washers
I _ FourWashers
Straight Shaft models /_j_--k_J
include 2 PlateWashers _
Fig. 1
INSTALLING CUTTING ATTACHMENT SHIELD
Use the following instructions if the cutting attachment
shield on your unit is not installed. Use only the
instructions that apply to the type of shaft and shield
that your unit is equipped with.
FOR CURVED SHAFT TRIMMERS
Place the cutting attachment shield and spacer against
tube as shown in (Fig.2). Use the 2 screws provided
to clamp the cap and shield onto the tube. Tighten the
screws evenly. Make sure the shield does not touch
any rotating parts.
CuttingAttachment Shield
Fig. 2
FOR STRAIGHT SHAFT TRIMMERS
Place the cutting attachment shield onto the shaft
mount. Install using provided hardware in the sequence
as shown (Fig.3). Ji
Shaft Mount
\
I I
I I
i Cutting Attachment Shield
Plate Washer "'_ _
Washer _
Lock Washer Attachin( Screws
Fig. 3
INSTALLING THE UPPER HANDLE AND SAFETY BAR
1. Locate the 4 screws included in the tool kit.
2. Assemble the upper handle, safety bar and 4 attaching
screws as shown in (Fig.4). Position the handle parts
evenly over the rubber sleeve on shaft. Do not com-
pletely tighten.
3. While holding the unit in the operating position (Fig.
14), position the upper handle to the location that pro-
vides you the best grip.
4. Tighten the clamp screws evenly, until the upper handle
is secure.
Attaching
Screws "_'_I _ g
(_jk.1U pper Handle
__u bber_Sleeve
SafetyBar _ I _"_._-_
Fig. 4
WARNING:
To prevent serious injury, never operate the
trimmer without the cutting attachment
in place.