Filter
Top Products
CALL TOLL FREE 1-800-DR-OWNER 13
Attaching the Chipper Hopper
Tool Needed:
• (2) 1/2" Wrench or Socket
Tip: Insert a towel or large rag into the opening to keep the Bolts from falling into the Chipper.
1. Attach the Chipper Hopper to the machine using four (4) 5/16"-18 x 3/4" Carriage Bolts, four (4)
5/16" Flat Washers and four (4) 5/16"-18 Nylon Lock Nuts.
NOTE: Be sure to insert the bolts from the inside of the Chipper Hopper so that the threads are sticking out
(Figure 1).
2. Install a Flat Washer, then a Lock Nut on each bolt. Initially install the Bolts and Nuts finger tight
and then tighten the Nuts one (1) turn using two (2) 1/2" wrenches (Figure 1). Check to see that
the Hopper is centered on the Inlet Chute and then tighten the Nuts securely.
3. If you used a towel or rag in the Chipper opening, remove it now.
BE SURE TO FILL THE ENGINE WITH OIL AND GAS BEFORE USE
.
IF YOU START THE ENGINE WITHOUT
OIL IN THE CRANKCASE, THE ENGINE WILL BE DAMAGED BEYOND REPAIR AND WILL NOT BE
COVERED UNDER THE WARRANTY. SEE THE NEXT PAGE FOR OIL AND FUEL FILL.
Check the Tire Pressure
There should be 30 psi in each tire.
Figure 1
Chipper Hopper
Bolt (4)
Nut (4)
Washer (4)
Chipper Left Side Panel
A
ccess Cove
r
Inlet Chute