Country Home Products C123E-CHP Chipper User Manual


 
AFTER ANY BLADE OR WEAR PLATE MAINTENANCE OR ADJUSTMENT, ROTATE
THE CHIPPER DISK BY HAND. WATCH AND LISTEN CAREFULLY FOR ANY UNUSUAL
NOISES, CLICKING OR VIBRATION. IF ANY OF THESE ARE DETECTED, INSPECT THE
MACHINE FOR DAMAGE, REPAIR OR REPLACE ANY DAMAGED PARTS AND CHECK
FOR ANY LOOSE PARTS AND RETIGHTEN.
KNIVES MUST BE CHECKED AND MAINTAINED!
KNIVES MUST BE SHARP!
BE SURE TO REINSTALL THE KNIFE CORRECTLY AND DOUBLE
CHECK FOR TIGHTNESS!
CHANGING OIL
Your chipper is equipped with an oil drain valve to make changing the oil easy.
The valve is located on the engine, on the towing side of the machine.
Place engine level.
Disconnect spark plug wire and keep it away from spark plug. Disconnect battery (if
equipped with electric starter) at negative terminal.
With engine OFF but still warm open oil drain valve and drain oil into appropriate
receptacle.
Note: To open valve, push in and turn counterclockwise.
Close oil drain valve.
Remove dipstick (if equipped) or oil fill cap.
Add new oil (28 ounces). Fill to FULL line on dipstick or to point of overflowing at oil fill
cap. Do not overfill.
Replace dipstick or oil fill cap.
20