Filter
Top Products
CHECKING AND ADDING OIL
• Check oil level before starting the engine.
• Check level daily, or after every eight hours.
• Keep oil level at FULL.
• Do not overfill.
Oil filling procedure: first add 1 quart. Start and run engine at idle for 30 seconds. Shut
engine off and wait 30 seconds. Then add more oil slowly to bring level to Full mark on dipstick.
Oil checking procedure: before starting engine, check oil level.
• Place engine level. Clean around oil fill and dipstick.
• Remove dipstick and wipe clean with cloth.
• Push dipstick back in and remove to check oil level.
• Remove oil fill cap. Pour oil slowly.
• Fill to Full line on dipstick – recheck.
• Replace dipstick firmly.
FUEL
• Use clean, fresh, regular unleaded gasoline with a minimum of 85 octane. Fresh fuel
prevents gum from forming in the fuel system or on essential carburetor parts. Purchase
fuel in quantity that can be used within 30 days.
• Do not use gasoline which contains Methanol.
• Do not mix oil with gasoline.
CAUTION: Some fuels, called oxygenated or reformulated
gasoline, are gasoline blended with alcohols or ethers. Excessive
amounts of these blends can damage the fuel system or cause
performance problems. If any undesirable operating symptoms
occur, use gasoline with a lower percentage of alcohol or ether.
ADDING FUEL
• Fill tank outdoors or in a well-ventilated area, away from sparks, open flames, pilot lights,
heat and other ignition sources
• If fuel spills, wait until it evaporates before starting engine.
• Turn engine OFF and let engine cool at least 2 minutes before removing gas cap.
• Remove cap. Fill tank to approximately 1-½ inches below top of neck to allow for fuel
expansion. Be careful not to overfill.
• Replace cap before starting.
14