SKU 92146 For technical questions, please call 1-800-444-3353. PAGE 7
GROUNDING
WARNING!
Improperly connecting the grounding wire can result in the risk of electric
shock. Check with a qualified electrician if you are in doubt as to whether the
outlet is properly grounded. Do not modify the power cord plug provided with
the tool. Never remove the grounding prong from the plug. Do not use the
tool if the power cord or plug is damaged. If damaged, have it repaired by
a service facility before use. If the plug will not fit the outlet, have a proper
outlet installed by a qualified electrician.
17. This Pressure Washer requires a minimum water input flow of 3 gallons per
minute.
18. When dispensing detergent, apply the detergent to the cleaning area at low
pressure only. Then, spray the detergent off the cleaning area by using the
adjustable Nozzle.
19. CAUTION: The high pressure water flow can damage the work surface if
not used properly. Always test the spray in an open area first.
20. Never move the Pressure Washer by pulling on the High Pressure Hose.
Use the Handle provided on the top of the unit.
21. NEVER leave the Pressure Washer unattended when it is plugged into an
electrical outlet. It is hazardous to leave this unit unattended, especially
with an inadequate water supply. Turn off the Pressure Washer and unplug it
from its electrical outlet before leaving.
22. If water is leaking out of the Pressure Washer, immediately shut off the unit.
Unplug the Pressure Washer, and discharge all pressure before tightening
fittings or having repair work done by a qualified technician.
23. WARNING! People with pacemakers should consult their physician(s) before
using this product. Operation of electrical equipment in close proximity to a
heart pacemaker could cause interference to, or failure of the pacemaker.
24. WARNING! The warnings and precautions discussed in this manual cannot
cover all possible conditions and situations that may occur. It must be under
stood by the operator that common sense and caution are factors which cannot
be built into this product, but must be supplied by the operator.
SAVE THESE INSTRUCTIONS