Filter
Top Products
SKU 92146 For technical questions, please call 1-800-444-3353. PAGE 14
To Apply A Detergent:
1. Make sure the Pressure Washer is turned off and unplugged from its electrical out-
let.
2. Unscrew and remove the top of the Detergent Bottle (34A) and fill it with a mild
detergent speciffically designed for pressure washing use (not included). Never
use caustic or abrasive detergents. Then, replace the top of the Detergent Bottle.
(See Figure F, page 12.)
3. Remove the Spray Wand (13A), and replace it with the Detergent Bottle (34A).
(See Figure F.)
4. Plug the Power Cord Plug into an electrical outlet, turn on the water flow, and squeeze
the Trigger (23A) and allow water to flow through the Wand. Then, turn on the Pres-
sure Washer.
5. Apply the detergent so that it thoroughly covers the cleaning surface. NOTE: De-
tergents work best when applied at low pressure. Apply from bottom to top of the
object being cleaned to prevent the detergent from sliding down and streaking.
6. Allow the detergent to remain on the surface for several minutes. Lightly scrub
heavily soiled areas with a soft brush or cloth. Do not allow the detergent to dry on
the surface to be cleaned.
7. Turn off the Pressure Washer, and unplug its Power Cord Plug from the electrical
outlet. Turn off the water supply, and discharge any remaining pressure safely.
8. Remove the Detergent Bottle (34A) from the Spray Wand Extension (11A), and re-
place it with the Spray Wand (13A). (See Figure F.)
9. Plug the Power Cord Plug into an electrical outlet, turn on the water flow, and squeeze
the Trigger (23A) and allow water to flow through the Wand. Then, turn on the Pres-
sure Washer.
10. Thoroughly rinse the detergent from the cleaning surface.
11. When finished, turn off the Pressure Washer, and unplug its Power Cord Plug from
the electrical outlet.
FIGURE J
SPRAY WAND (13A)
KNOB (16A)
HIGH IMPACT STREAM
WIDE FAN SPRAY
WARNING:
NEVER adjust the knob
while the trigger is not
locked in the off position.